1. From the circuit shown in the figure, the statement below are true except (the transistor is Si) a. transistor has a collector emitter voltage of 8.7 V b. transistor dissipates a power of 13 mW c. transistor has a base-collector voltage of -8 V d. transistor is in the active region 2. From the figure, β of the silicon transistor is 49, the base current is equal to a. 1.274 mA b. 0 A c. 26 μA d. 1.3 mA

1. From the circuit shown in the figure, the statement below are true except (the transistor is Si) a. transistor has a collector emitter voltage of 8.7 V b. transistor dissipates a power of 13 mW c. transistor has a base-collector voltage of -8 V d. transistor is in the active region 2. From the figure, β of the silicon transistor is 49, the base current is equal to a. 1.274 mA b. 0 A c. 26 μA d. 1.3 mA

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Similar questions

Number 9 Please show your detailed solution. Number 9 Please show you detailed solution. A 50-ohm resistor is in series with a 40-?F capacitor across a constant potential source of 180 volts. Determine frequency that will give current of 3.13 amp. A. 250 Hz C. 160 Hz B. 200 Hz D. 140 Hz
c) An AC bridge in the Figure Q1c is balanced at 1 kHz and has the following components: Arm AB has 1.5 µF of capacitance in parallel with 2 kQ variable resistance Arm AC has 1 kO resistance Arm BD has 2.7 kQ variable resistance Arm CD has an unknown inductor, L. and a resistor, R, connected in series i) ii) iii) Sketch and show the components of the bridge. Classify the type of the bridge. Compute the unknown inductor, L, and resistor, R. A Z2 AC Z3 Zx D Figure Q1c
The circuit in the figure below contains two resistors, R1 = 4.00kΩ and R2 = 5.00kΩ, and two capacitors, C1 = 4.00uF and C2 = 5.00uF, connected to a battery with emf E = 120V. If no charges exist on the capacitors before switch S is closed, determine the charge q1 on capacitor C1 1.00ms after the switch is closed. Determine the charge q2 on capacitor C2 1.00ms after the switch is closed.
8 The figure is a graph of . Current Voltage the current across a voltage as a function of the potential difference through it the resistance as a function of the current across a component the current through a component as a function of the voltage across it O All three of the above (a), (b), and (c) are true O None of the above (a), (b), or (c) is true
A capacitor of capacity C₁ is charged upto V volt and then connected in parallel to an uncharged capacitor of capacity C₂. The final potential difference across each will be (a) (c) C₂V G₁ + C₂ (1+2) GV G + C₂ (4) (1-²) v (b)
Consider a PV Module with 4 solar PV cells with the Size of each 10cm x 10cm are connected in Parallel. Choose the correct statement for the above PV Module. (Assume necessary data) a. The output voltage is 0.5 V, the output power is 12W b. The output voltage is 2 V, the output power is 12W c. The output voltage is 12 V, the output power is 6W d. The output voltage is 0.5 V, the output power is 6W
A thermistor is placed in a 200°C environment and its resistance measured as 30000Q. The material constant B is 3627°K. If the thermistor is then used to measure a particular temperature and its resistance is measured as 6002. The thermistor temperature in °C. Select one: O a. 573 Ob. 255 OC. 692.64 d. 965.64
R1 R2 R3 10V Compute the energy stored in the capacitor in micro-Joules given the following component values R1=30 R2-8 2 R3=3 2 L=3.2 mH C-6.1HF Note: Round your answer to the nearest single digit decimal place. Your answer should be in micro-Joules. For example.
A capacitor C with 1 mF is charged by a constant voltage source (U). Source and capacitor are connected by a resistor R with 10 ko. To discharge the capacitor the source is replaced by a short. U R 1 R charging discharging The voltage source is replaced by a constant current source with an output of 1 mA. Please draw the voltage at the capacitor qualitatively over the time.
Find the resultant system of converging forces in the 500 N figure. Below 20ON 30ON
A voltage of .... appears between the terminals of a combination of a 100 mF capacitor and a 12 oms resistor in parallel. Calculate the power absorbed by the parallel combination. Note: I leave the image of the exercises in Spanish, but it is easy to understand. Also in the other image is the correct final answer, for checking.
Exe: The single-phase bridge rectifier has an RL Load and an ac source, with R = 10Ω andL = 10mH. The peak value of the source is Vm = 100V at 60 Hz. The expressions of voltage andcurrent outputs are:(a) Determine v0(t) and i0(t) with two ac terms (n=2 and 4)(b) Determine the power absorbed by the load.