3) The ME Department just purchased a new mega-drone that weighs 220 lbs and can descend autonomously to land on its own. The drone company included the graph shown below for how much force is applied to the Thrust 'T'. If the operator allows the autonomous descent when the drone has an initial downward velocity of 2 ft/s, calculate the velocity of the drone after 3 seconds.

3) The ME Department just purchased a new mega-drone that weighs 220 lbs and can descend autonomously to land on its own. The drone company included the graph shown below for how much force is applied to the Thrust 'T'. If the operator allows the autonomous descent when the drone has an initial downward velocity of 2 ft/s, calculate the velocity of the drone after 3 seconds.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q1 [Type B]: The 20-lb crate A rests on a smooth surface. If the crate starts from rest and P = (t² + 1.5t) lb where t is in seconds, determine the speed of the crate A at t = 2 s using the method of linear impulse and momentum. Not using the required method would result in a 0 for this question. A Shaobo Huang P 30⁰
OR Fig. 3 A robotic arm shown in Fig. 3 is programmed so that the 0.4-kg part A traces the radial path defined by r = 1–- 0.5 cos (2nt) meter and tranverse path of 0 = 0.5 – 0.2 sin (2nt) rad respectively. a) Calculate the velocity magnitude of part A at 1= 3 seconds. b) Determine the radial and transverse components of the force exerted on A by the robot jaws at 1= 2 seconds. Show the necessary Free-Body and Kinetic diagram to support your analysis.
Big Boris (90kg) skates backward, 1.0 meter ahead of small skater Sofia (45 kg) , holding her hand as they travel 3.0 m/ At the 30-second mark, Boris starts pulling Sofia, so that by time 32.0 s she is 1.0 m ahead of him. During that move, how hard was Sofia pulling Boris? 1/3 as hard as Boris pulled Sophia (but backward) half as hard as Boris was pulling her (but backward) just as hard as Boris was pulling her (but backward) O 2/3 as hard as Boris pulled Sophia (but backward) 3 times as hard as Boris pulled Sophia (but backward) Boris pulled Sofia - she didn't pull him twice as hard as Boris was pulling her (but backward)
I Suppose an autonomous surface vessel (ASV) traveling with velocity TvG/O= vi₁ begins to make a turn by adjusting the thrust of its left and right thrusters, TA and TB, respectively. The center of mass of the ASV is located at G and the ASV is symmetric about its vertical axis. The ASV also experiences a drag force that is proportional to its speed and opposes its velocity. At the instant shown, the drag force is D = -kvi₁ where k is a drag coefficient. 1. To model the mass moment of inertia, approximate the ASV as consisting of three rigid bodies: a flat plate as a center body of mass 6m and two slender rods housing the propulsion assemblies, each of mass m, at the outboard sides of the vehicle. Determine the mass moment of inertia, IG, about the vertical axis passing through the center of mass G. (Hint: Use the parallel axis theorem.) 2. At the instant shown, determine the inertial acceleration vector ac/o = axi₁ + ayi2 of the center of mass and the angular acceleration a of the…
Pbm 7) Elevators A and B in the adjoining shafts start moving in opposite directions with constant accelerations 0.3 m/s2 and 0.6 m/s² respectively. A moves down while B moves up. If they were 150 m apart at t = 0, after what time they will be opposite to each other? How far each one has travelled?
4) A spacecraft designed for Martian impact is on a course heading directly toward the center of the planet. If the spacecraft is 10,000 km from the surface of the planet and is traveling at a relative speed of 20,000 km/hr, compute the impact velocity, v. The gravitational acceleration at the surface of Mars is g = 3.73 m/s^2, and the planet has a diameter of 6800 km. Neglect atmospheric resistance. ANS. V₂ = 7055 m/s = 25,400 km/hr FBD AND KINEMATICS DIAGRAMS
The figure below shows a diver going through general motion. The diver's center of gravity can be assumed to undergo a projectile motion. Assume that the diver takes off from a diving board such that his center of gravity is a height ho = 11m above the water level and enters the water at a horizontal distance 1 = 4m from the end of the board. If the total time the diver remains in the air is t2 = 2.3s, calculate the speed, vo, and angle of takeoff ,O, of the diver's center of gravity. Also determine the height, hi, the diver reaches at the top of the dive. (Note that tr is NOT half of t2.)
We want to design a wagon system like the one below while filling the kiln with coal at the Coke factory inside Kardemir. In this system, we want the wagon to reach a speed of v= 1 m/s in t=2 seconds. It will then shoot at constant speed. How much engine power is required to tow a wagon with W= 500 kgf under these conditions P=? (Losses will be ignored). (The slope angle of the ramp is α= 25 degrees.)
Body U with mass 5m is stacked on the top body W with mass m, and released. The bodies are in contact along the frictionless interface at 45° to the vertical. The body U is in contact with the frictionless vertical wall. Body W lies on the floor with coefficient of friction u. Relevant dimensions are shown in the figure. Express the results in terms of given quantities: m, g, h and µ (except when µ is given numerically). You need not evaluate sin 45° = cos 45° = 2/2. h U: 5m C 45 D W: m 3h
An engineer group studies on the design of a tour balloon for Cappadocia. It is planned that the design details will be determined through the use of a small-scale model for a prototype balloon. The prototype balloon will be departing from a hill with 30 m height. In the small-scale model, a platform with 0.1, m height will be used to simulate the hill. h = f(t, ho, Vo, g) a) Determine the initial vertical speed (Vo) of the balloon when the initial vertical velocity for the model is found to be 3 m/s. Vo b) How long will the prototype reach the height that the model reaches within 33 minutes? ho c) Calculate the corresponding height (h) for the prototype when the height is 60 m for the model. h = 0
A car passes over a hill as shown. Determine the following. a. Equation for the maximum speed of the car and still maintain contact with the road (in terms of r and g) b. Traveling at the same speed, what is the equation for the normal reaction of the road to the car when it passes the lowest point? If r = 50 m, determine the maximum speed in mph without catching air. The maximum normal force in Newtons at the low point if the car weighs 3000 lbs c. d. r + r
UBC Engin A trebuchet uses a falling counterweight to launch a projectile. It can be thought of as a machine that converts the gravitational potential energy of the counterweight into kinetic and gravitational potential energy of the projectile. The counterweight has a mass of 100kg and drops 3m. The projectile has a mass of 3kg, and starts on the ground. When it leaves the sling, it has a height of 4m speed of 30. m If the average power used in lifting the counterweight is 48W, find the time it takes to lift it from the ground to its full height. tlifting If the projectile goes from rest to its maximum speed in 1.5s. find the average power used in launching the projectile in this time period. Pprojectile Find the efficiency of the trebuchet when it launches. Efficiency % W