A 500 mL sample of a 0.100 M formate buffer, pH 3.75, is treated with 5 mL of 1.00 M KOH. What is the pH following this addition?
Q: How many moles of Na,SO4 are in 100.0 mL of a 0.2500 M solution ? The GFW is 142.07 g. O A. 0.0500…
A: 0.25 M Na2SO4 solution. Molarity = number of moles in 1L of solution So, 0.25 moles of Na2SO4 in 1 L…
Q: How much of a 10x buffer should be added to 900ml of water to make a 1x solution?
A: In this question, we are given with- 1. Concentration of stock solution= 10X 2. Required…
Q: How many moles of EDTA (C10H16N2O3) do you have in 785µl of a 74MM EDTA solution (Mr(C10H16N203) =…
A:
Q: A 100-mL buffer solution with pH of 4.80 is prepared as a stock solution. Using this stock buffer…
A: Hi! Thank you for the question. We are authorized to answer two subparts at a time, since you have…
Q: What is the Molarity of 10 grams of NaCl dissolved in 3L of solvent?
A: Molarity of the solution is equal to the number of moles of solute present in one liter of solution.…
Q: Sodium Citrate 5 g Tartar Emetic 0.015 g Cherry Syrup ad 120 mL Using a balance with a sensitivity…
A: Correct answer is 22.5 ml Examplnation given with image in step 2
Q: What are the pH values for the following solutions? (a) 0.1 MHCl (b) 0.1 M NaOH (c) 0.05 M HCl (d)…
A: pH is the scale used to specify the acidity or basicity of an aqueous solution. It is the negative…
Q: A solution measuring pH 12 is _________ times __________ concentrated with H+ than a solution…
A: The term "pH" was first described by Danish biochemist Soren Peter Lauritz Sorensen. pH is defined…
Q: 50 mL of 5mM NaCl solution from 1 M NaCl solution
A: Dilution is the process by which we decrease the concentration of a solution. This process is vital…
Q: What is the approximate pH of a solution labeled 6 x 10-5 M HBr? * 4.2 O 4.5 5.8 O 9.8 O 8.2
A: pH is the measure of the strength of H+ ion or Hydronium ions in solution. pOH is…
Q: You have 150 g of dextrose available and you need to compound a 20% solution. If you use the entire…
A: When we describe a concentration as a percentage without specifying the type of formula, we imply…
Q: 4. 25.0 mL of an unknown acidic solution was titrated with 42.7 mL of a 0.15 M NaOH solution. What…
A:
Q: How many grams are in 1 mL for the following solution? NS _________ this is the whole question
A: NS or Normal saline: It is nothing but a mixture of sodium chloride (NaCl) and water that is…
Q: You are asked to prepare 50 ml of a 1:100 rifampin (rifadin) and you have in stock a 1:20 rifampin…
A: Rifampin (Rifadin) is an antibiotic used to treat bacterial infections like leprosy, tuberculosis…
Q: How many grams of sodium chloride are needed to make 0.60L of 2.3M sodium chloride solution
A: The concentration of a solution is expressed in molarity. Molarity is defined as the number of moles…
Q: What is the pH of a 0.0032 M solution of NaOH?
A: pH is a scale which is used to specify the acidity or basicity of an aqueous solution. The pH scale…
Q: If I have a 20ml stock solution of BSA with a BSA concentration of 0.2%. How can I make two other…
A: The concentration of the stock solution of BSA is 0.2%. Percent solution is the mass of solute…
Q: If a 1.20 L of strawberry wine is 10.5% alcohol by volume, how many ml of the solution is ethanol?
A: Wine is an alcoholic beverage produced from honey, fruits like grapes, pineapple, strawberry, etc.…
Q: What is the pH of a 6.7 × 10⁻⁶ M HBr solution?
A: Hydrobromic (HBr) acid is considered a strong acid, which means it gets completely dissolved into an…
Q: 20 mL solution is 2 M NaOH. If 0.5 M HCl is to be added to this solution, calculate the pH of the…
A: pH is the negative logarithm of hydrogen ion, used to measure the acidity and basicity of the…
Q: How many grams of copper sulfate would you need to make 5 L of a 7 M copper sulfate solution?
A: Molarity is defined as the moles of solute per litre of the solution. Hence, our target is to make…
Q: You need to prepare 1L of a 5×TE stock solution (1×TE buffer:10mM Tris,1mM EDTA).How much of Tris…
A: The mole is used as a unit in the SI system to quantify the amount of substance present. One mole is…
Q: you have an order to administer 100 mg of Ceclor to a patient you have a bottle of liquid suspension…
A: Performing drug dsage calculation is an essential skill in health care. Health-care professionals…
Q: How do you prepare 500 mL pH 6 Citric acid/Phosphate buffer in the laboratory. Please explain…
A: A buffer solution is a solution that only changes slightly when an acid or a base is added to it.
Q: What is the ratio of TRIS/TRIS-H+ in a TRIS buffer at pH 8.7?
A: TRIS is tris aminomethane. It is an organic compound. It is mostly used as a component of buffer…
Q: What is the final volume of NaOH solution prepared from 100.0 mL of 0.500 M NaOH if you wanted the…
A: The solution is a homogenous mixture of two or more components mixed together. It has two…
Q: Given a BSA stock solution of 4mg/mL how would you prepare a 5 mL sample with a final concentration…
A: The following formula is used to find the volume required to prepare a 5 mL sample with a final…
Q: 50 mL of 15 mg/mL NaOH solution from 100 mg/mL NaOH
A: Sodium hydroxide is an inorganic compound with the formula NaOH. It is an ionic compound consisting…
Q: What would be the working stock concentration (in molarity) if you diluted 250 uL of a stock…
A: Molarity is defined as the number of moles dissolves in 1000 ml of the solution.
Q: What is the pH of a 5.9 × 10⁻⁶ M HBr solution?
A: Hydrobromic acid, HBr is an extremely strong acid, one that ionizes completely ionizes completely…
Q: If 10g of salt was mixed in 1L water. What percent solution will this be.
A: According to the question,Mass of solute = 10 grams = 10gVolume of water = 1L = 1000 mili Liters…
Q: given a stock solution of 10% dextrose, how would you make 5 mL of a 0.9% dextrose solution? find mL…
A: Given Values: The concentration of the stock solution of dextrose = 10% Concentration of the final…
Q: How many moles of KBr are there in 89.5 mL of 0.150 M KBr?
A: Molarity can be stated as, it is the number of moles of solute which is dissolved per liter (L) in…
Q: An aqueous solution is 3.50 % by mass hydrochloric acid, HCl, and has a density of 1.02 g/mL. The…
A: Mole fraction is expressed in the terms of moles. It is can be calculated from the formula that is…
Q: Make a standard curve by using the values given in the table and determine the concentration of…
A: Bovine serum albumin or BSA is used for standard curve preparation because of its stability. The…
Q: f there is a stock solution of 2000 (ug/ml) , is it possible to use SERIAL DILUTION to generate the…
A: The stock solutions are the concentrated solutions which can be used to prepare the solutions of…
Q: Tris NaCl buffer is known as?
A: Tris (with HCl) has a slightly alkaline buffering capacity in the 7–9.2 range. The conjugate acid of…
Q: Assume that you have a stock solution of 10% SDS and you need to make 150 microliters of 0.5% SDS.…
A: Stock solution (SDS) = 10%Concentration of stock solution = 10g of SDS/ 100ml of water.Similarly,…
Q: You are asked to make a 5M solution of SO 2, how many grams do you need?
A: A solution is a homogenous mixture that is homogenous. It is made up of two substances or more…
Q: How many moles of HCl are there in 75.0 mL of 0.160 M HCl?
A: Molarity can be stated as the soluble moles of solute, which is dissolved per liter of solution.
Q: The pH of a solution containing 20 mL of 0.120 N NaOH and 35 mL of 0.120 N NaOH is 1.49. True or…
A: Given Values: 20 ml of 0.12 M NaOH and 35 ml of 0.12 M NaOH are mixed together. The pH of the mixed…
Q: what is the is the dilution factor when you add 2 mL ssample of 8 mL diluent?
A: Dilution is a process of changing the concentration of the solution by addition of solvent, which is…
Q: alanine that would exist at the pH indicated below.
A:
Q: What is the pH of an aqueous solution with {H3O+} = 6x10-12
A: pH is logarithm of the reciprocal of the H+ or H3O+ ion concentration in a solution that is…
Q: What is the pH of the following buffer mixtures? (a) 100…
A: Given values: (a) Volume of acetic acid = 100 ml Concentration of acetic acid = 1 M Volume of sodium…
Q: If 4 mL of 1 M NaOH is added to 100 mL buffer, would it still be a usable buffer according to the…
A: A buffer can be destroyed by adding either a strong acid or a strong base in a large amount. The…
Q: How many liters of a 7 M NaOH stock solution would you need to make 780 mL of a 153 mM NaOH…
A: Molarity is defined as the number of moles of solute present in a liter of solution. Molarity =…
Q: Approximately how many fluid ounces of sterile water are needed to compound this solution?
A: It has been mentioned that the sterile water needed to prepare this solution is 100 ml. The question…
Q: What quality of zwitterions makes them desirable buffers?
A: A buffer is a solution that can withstand pH changes when acidic or basic components are added. It…
A 500 mL sample of a 0.100 M formate buffer, pH 3.75, is treated with 5 mL of 1.00 M KOH. What is the pH following this addition?
Trending now
This is a popular solution!
Step by step
Solved in 3 steps
- 50X TBE is 87 mM Tris-borate and 4 mM EDTA at pH 8.3. What is the molarity of each of the chemicals in 1X TBE buffer?439 mL of 0.270 M hydrochloric acid is exactly neutralized with 0.920 M potassium hydroxide solution. What volume of base solution is required?You need to prepare 1L of a 5×TE stock solution (1×TE buffer:10mM Tris,1mM EDTA).How much of Tris you need? How many ml of the 0.5 EDTA stock solution do you need?
- Given a BSA stock solution of 4mg/mL how would you prepare a 5 mL sample with a final concentration of 1 mg/mL?If 4 mL of 1 M NaOH is added to 100 mL buffer, would it still be a usable buffer according to the conventions? Explain why or why not.TE buffer consists of 10 mM of Tris-Cl, pH 7.6 and 1mM of EDTA, pH 8.0. You need to prepare 3L of TE buffer and you have the following stock solutions: 500 mM Tris-Cl and 1 M EDTA. How will you prepare the 3L of TE? Write work clearly
- Titration of a 12.0 mL solution of HCl requires 22.4 mL of 0.12 M NaOH. What is the molarity of the HCl solution?How much of a 5x buffer and how much water should be added to make 1 L of a 1x solution?You need to prepare an acetate buffer of pH 5.43 from a 0.621 M acetic acid solution and a 2.95 M KOH solution. If you have 730 mL of the acetic acid solution, how many milliliters of the KOH solution do you need to add to make a buffer of pH 5.43? The pKa of acetic acid is 4.76. Be sure to use appropriate significant figures.
- A 25.00 mL sample of 0.320 M LIOH is titrated with 0.750 M HNO3 at 25 °C. Calculate the initial pH before any titrant is added. pH = Calculate the pH of the solution after 5.00 mL of the titrant is added. pH =What is the final volume of NaOH solution prepared from 100.0 mL of 0.500 M NaOH if you wanted the final concentration to be 0.150 M?If a pharmacist needs to prepare a bacterial suspension with a concentration of 2.4x10^2 cfu using 1 mL of 2.4 x 10^4 bacterial suspension, what size of volumetric flask will she/he be needing?