A conductor has a resistance of R. it was cut into ten even pieces. Six of them are connected in series, four are connected in parallel. Then they are again connected in series. Find the total resistance.

A conductor has a resistance of R. it was cut into ten even pieces. Six of them are connected in series, four are connected in parallel. Then they are again connected in series. Find the total resistance.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Related questions

Q: Use Thevenin's Theorem and Norton Theorem to determine the Resistance, Current and voltage at branch…

Q: Apply or Use Kirchhoff’s Laws in solving currents and voltages in a circuit

A: To solve above problem, we will use Ohm's law and Kirchhoff's law: Ohm's law state that in a current…

Q: How are Kirchhoff's laws of voltage and current, and the series and parallel circuit analysis…

A: Krichhoff's law of Current :- It is defined as the sum of the current entering the node is equal to…

Q: Refer to the figure, find the mesh currents (a) I1, (b) I2, and (c) I3.

A: The given circuit is shown as,

Q: Determine the currents I1, 12, l3, and l4 from the given circuit below. a 40Ω 60Ω I2- 12V TE500 ЗА…

A: Given circuit is -

Q: Construct the series-parallel circuit in below. Use R1 = 330Ω, R2 = R3 = 1kΩ using Proteus…

A: The sum of voltage drop is equal to the sum of voltage rise inside a closed loop. The 10V input…

Q: the value of Vs1,Vs2 ,Vs4 and Vs6 = 10 volt and the value of all resistance is 1 kilo ohm .Using…

Q: For the series circuit shown in Figure, find the following quantities: a. Total resistance, RT. b.…

Q: Determine the Norton’s equivalent circuit across points A and B by disconnecting the 75-ohm…

A: In the circuit, Determine the Norton’s equivalent circuit across points A and B by disconnecting the…

Q: 1. What is the current through R1? 2. Is the current through R1 going from "a to b" or from "b to…

A: E1=240 VE2=480 VR1=33 ΩR2=7 ΩR3=10 ΩR4=40 Ω

Q: Find V1, V2 and V3 of the circuit given in Figure 1 using nodal analysis

A: This question belongs to circuit theory . It is based on the concept of super node and nodal…

Q: Q2 (a) Explain the concepts of Kirchhoff's Voltage Law (KVL) and Kirchhoff's Current Law (KCL) with…

A: "As per our guidelines, we are supposed to answer only one question. Kindly repost the other…

Q: Determine the power across resistors R1, R3 and R5 using Kirchhoff's Law.

A: It is given that:

Q: Determine: (a) currents I1, I2, I3, and I4 and (b) the voltage across the current source

A: Given circuit:

Q: Find the equations of the junctions and loops ( V instead of I and R )

A: Mesh Current Analysis is a technique used to find the currents circulating around a loop or mesh…

Q: the circuit shown in figure (1), solve the circuit using chhoff's laws to determine currents and…

Q: Elaborate the role of Multimeter in Electrical Engineering field, justify your answer with practical…

A: Multimeter is a device which is frequently used in electrical laboratory and in electric power…

Q: For the following circuit determine each of the currents I1, I2, I3, I4 and the resistance R3

A: By ohms law current through the resistor =(voltage across the resistor)/resistance. By KCL sum of…

Q: Please show complete solutions Find the values of the current flowing, the voltages and the power…

Q: Find the current in each branch and voltage across each resistor using kirchhoff's law

Q: Find the equivalent resistance to the combination shown on the right.

A: When two resistors R1 and R2 are connected in series, the same current flows through them. The…

Q: Question 1: A resistive network is given in the figure. Given R1 = 200N, R2 = 3000, R3 = 5002, R4 =…

A: As per image in question,we have,

Q: Determine (a) currents I1, I2, I3, and I4 and (b) the voltage across the current source.

Q: Apply Kirchhoff’s Laws in solving currents in a circuit

A: In this question, Apply Kirchhoff’s Laws in solving currents in a circuit? Here 3 independent KVL…

Q: Using applicable Kirchhoff's Laws, determine voltages v1, v2 and v3 of the circuit below. vị - ww +…

A: Ans. Is shown below.

Q: Find the branch currents and power in each resistor using Kirchhoff's Laws. 30 ЗА

A: To find the branch currents and power absorbed by each resistors

Q: Wheatstone bridge as shown in Figure Q4(a) consists of four resistive arms forming a closed circuit…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: For this Supermesh question, I got all of the values for the currents, and how much power was…

Q: What does the slopes represent in V & I relationship?

A: So according to ohms law we know that I =V/R or V/I=R where R is the resistance. Resistance is…

Q: circuit in which R= 10 ohms and L= 0.1 Henry. This is energized by a 24 volt DC source. If the…

Q: Compute for the currents per node as indicated in the figure below. Use KCL and KVL equations. Then,…

Q: For the circuit shown in figure, solve the circuit using Kirchhoff's laws to determine currents and…

Q: In the circuit in the figure, the primary current is read as 3.603mA. Two windings were used as…

A: The transformer has a primary and a secondary side. It converts electrical power to electrical power…

Q: Hello, I find difficult solving this problem. This problem is to find the equivalent resistance…

Q: Q2/ For the network of Figurel. a. Determine Z; and Z, . b. Find Ap. 12V 22 a 220 k2 #-60 -40 k2

Q: Ohm's law states that the voltage drop Vacross an ideal resistor is linearly proportional to the…

A: A table is given in the question which contain the experimental values of voltage drop across a…

Q: how i solve this circuits with

Q: Q4) The resistance of two wire is 25 Q when connected in series and 62 when connected in parallel,…

A: When resistance are series add them When in parallel for 2 resistors Use the following formula We…

Q: what can you conclude when we sum up the voltages across a loop/branch? What value is it equal to?

A: Given: Brief description: From the above circuit diagram we can easily say that , in the circuit we…

Q: In the figure shown below, the current through loop 1 be 1 and through the loop 2 be 12, then the…

A: To solve above given problem one should have idea about circuit theory. In circuit theory whatever…

Q: Find equivalent resistant

A: Given circuit,

Q: Consider the L-C-R electrical circuit shown in Figure I below. Figure 1 (a)Draw a linear graph for…

A: Given circuit

Q: the parallel circuit as shown below. R1 and R2 are 10 Ohms and

A: The voltage is constant when the resistances are connected in parallel and when resistances are…

Q: solve for the indicated currents in the circuit of the figure below using kirchhoff's law

A: The solution can be achieved as follows.

Q: Use wye formula in the red sketch, the part where there is circle find the resistance parallel to…

A: To convert Delta to star To find V1 and V2

Q: i in Ro Ro v2 v2 Vị v1 V1 a) b) c)

A: From figure (a) V1=-RoI2 and V2=-RoI1 From figure (b), let Z=R+jXL where XL is inductive reactance.…

Q: Determine the currents and powers i1, i2, i3 and i4 in the figure ЗА -> 12 V 452 20 V

A: From the KVL and KCL

Q: R2 R, L1 E1 E2 L2 RA '4 R3 E4

Q: b. For the circuit shown in Figure Q1(b); i. Analyze the circuit using nodal method and find the…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

A conductor has a resistance of R. it was cut into ten even pieces. Six of them are
connected in series, four are connected in parallel. Then they are again connected in
series. Find the total resistance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A conductor has a resistance of R. It was cut into twelve even pieces. Six of them are connected in a series, six are connected in parallel. They are again connected in series. Find the total resistance.
Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l33.2AI4RT3.582R116R210R3R420PTP1P2P3P4
The voltage across the resistor in series RL when suddenly supplied by a DC source is? a. zero O b. minimum O c. infinity O d. maximum
what us the resistance of teb 240- resistors connected in series? in parallel?
A secondary cell having an e.m.f. of 2V and an internal resistance of 1 ohm is connected in serieswith a primary cell having an e.m.f. of 1.5V and an internal resistance of 100 ohm. The negativeterminal of each cell is connected to the positive terminal of the other cell. A voltmeter having aresistance of 50 ohm is connected to measure the terminal voltage of the cells. Calculate the voltmeterreading and the current in each cell.
1. A 5-ohm resistance is connected in parallel with a 10-ohm resistance. Another set, a 6-ohm and an 8-ohmresistances are also connected in parallel. The two sets are connected in series. What is the total resistance?
In cross circuits, how do i know the resistances are in parallel or in series connection?
A Moving to another question will save this response. Quèstion 12 Paramagnetic materials have relative permeability Equal to unity Equal to that ferromagnetic materials Slightly more than unity Slightly less than unity P Type here to search hp
conclusion and observation in Kirchhoff's Current Law and Kirchhoff's Voltage Law
Two resistors RA and RB are connected in series across a 120-V source. When a 30,000-ohm voltmeter is connected across RA and then across RB, the instrument deflection is 48 volts in each case. What are the ohmic values of the resistors?
What is the voltage across the 50 Ohm and 5 Ohm resistors? Using the loop hole equation, what is the voltage across the R1? What is R1?
shfdjkfdrhnacoioeniodinopidopdnieocmixoxwmipdf.ziudSALIDUDetu The equivalent resistance of three resistors A, B and C connected in parallel is 1.5 ohms. If A is thrice of B and C is 1/4 of B. Find the equivalent resistance when the three of them are connected in series? dhffrriru9ee