A short-shunt d.c. compound generator supplies 250A at 50V. The r shunt field windings are 0.02, 0.08 and 50 ohms respectively. Find th The armature current la The generated voltage Eg An 8-pole d.c. generator has 455 armature conductors, and a usefu the e.m.f. generated if it is lap-connected and runs at 1060 rpm? W driven produce the same e.m.f. if it is wave-wound?

A short-shunt d.c. compound generator supplies 250A at 50V. The r shunt field windings are 0.02, 0.08 and 50 ohms respectively. Find th The armature current la The generated voltage Eg An 8-pole d.c. generator has 455 armature conductors, and a usefu the e.m.f. generated if it is lap-connected and runs at 1060 rpm? W driven produce the same e.m.f. if it is wave-wound?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The terminal voltage of a 150 kW series generator is 600 V at rated load. The armature resistance is 0.06 ohms and the series field resistance is 0.04 ohms. Find generated emf.
There are 144 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors in each slot and all the conductors in a phase are connected in series. Coil span is 1500 electrical and the flux per pole is 0.05 Weber sinusoidallly distributed. Calculate the emf induced per phase.
Fill in the following blanks:1. Lap winding is suitable for ……. Voltage, …… current d.c. generators.2. The critical resistance of the d.c. generator is the resistance of ……. .
A 2 pole wave wound dc generator has 44 slots, each slot having 20 conductors. The flux/pole is 0.018 weber. At what speed the armature be rotated to get an induced emf of 220 V. What will be the induced emf developed if the armature winding is lap connected and runs at the same speed. Speed Generated Emf when lap connected
A small single-phase 60 Hz transformer has 10.2 W at no load. The core has a volume of 750 cm3. The maximum flux density is 10,000 G and the hysteresis constant of the core is 0.0005. Using the Steinmetz law on hysteresis loss, find the eddy current loss.
A three-phase, 4-pole, 1,500 rpm alternating having a double layer-windings with 18 turns per coil. The slots per pole per phase are 10 and the coil span is 22 slots. The spread phase is 60 degrees and the flux per pole is 0.0625 Weber. If the armature windings are wye connected. a) Determine the generated voltage per phase and the line to line voltages. b) If the alternator is delivering a three - phase load of 1,200KW at 0.8 lagging power factor what is the line current of the alternator
1.) A 6-pole, 3-phase, 60-Hz alternator has 12 slots per pole and four conductors per slot. The winding is 5/6 pitch. There are 0.025 Wb entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. The winding is wye-connected. Determine the open circuit emf per phase of the alternator. Subject Electrical machine 2
A wave wound armature of an eight-pole generator has 06 slots. Each slot contains 16 conductors. The voltage required to be generated is 300 V. What would be the speed of coupled prime mover if flux per pole is 0.05 Wb.If the armature is rewound as duplex lap wound machine and run by same prime mover, what will be the generated voltage.
A d.c. generator has an armature e.m.f. of 100 V when the useful flux per pole is 20 mWb and the speed is 800 r.p.m. calculate the generated e.m.f. (i) with the same flux and a speed of 1000 r.p.m. (ii) with a flux per pole of 24 mWb and a speed of 900 r.p.m.
What are the conditions in paralleling of these DC Generators:a. Shuntb. Seriesc. Compound
1. In a transformer, which options are correct:A. Works on Faraday’ law and Ampere’s lawB. DC current in the primary winding will produce voltage output in the secondary windingC. Copper losses are caused by reluctance in magnetic circuitD. Frequency of input power source will not govern the voltage induced in secondary circuit.2. Voltage ratio of input voltage and output voltage in IDEAL transformer depends on:A. Leakage fluxB. Magnetization currentC. Copper loss currentD. Turns ratio3. The core of transformer must have:
7 A three-phase, 60-cycle, 32-pole synchronous generator has a sinusoidally distributed air-gap flux of 0.025 weber/pole. The armature core has 324 slots. The armature winding is Y-connected. There are two coil sides per slot and two turns per coil. The coil pitch is 9 slots. Find the generated voltage between the line terminals. Ans. 2,445 V