A soil is mixed at a water content of 16% and compacted in a 1000 ml cylindrical mold. The sample extruded from the mold has a mass of 1620 g, and the specific gravity of the soil grains is 2.69. Find the following: a. void ratio, b. degree of saturation, and c. dry unit weight of the compacted sample. d. If the sample is soaked in water at the same void ratio, what would be the new water content?

A soil is mixed at a water content of 16% and compacted in a 1000 ml cylindrical mold. The sample extruded from the mold has a mass of 1620 g, and the specific gravity of the soil grains is 2.69. Find the following: a. void ratio, b. degree of saturation, and c. dry unit weight of the compacted sample. d. If the sample is soaked in water at the same void ratio, what would be the new water content?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A Dry sand is placed in a container 9 cm3. The dry weight of the sample is 15 g. Water is carefully added to the container so as not to disturb the condition of the Sample. When the container is filled the combined weight of soil and water is 18 g. Determine the following: the Void ratio of sample in the container Porosity Water constant Specific gravity of the soil particle Saturated unit weight Dry unit weight
3. A dry sand is placed in a container 9 cm3. The dry weight of the sample is 15 g. Water is carefully added to the container so as not to disturbed the condition of the Sample. When the container is filled the combined weight of soil and water is 18 g. Determine the following: a) Void ratio of sample in the container b) Porosity c) Water constant d) Specific gravity of the soil particle e) Saturated unit weight f) Dry unit weight
Q2: A 0.01 m' of saturated soil sample has a unit weight of 1.6g/cm3. After it is dried in the oven, the weight of the soil sample reduced to 13.5kg. Use a phase diagram, determine the following: Weight of water for the saturated soil, Ww Water content, wc Ws WATER Void ratio, e Porosity, n SOLID befare trng W. Va SOLID efter ening
The wet weight of a soil specimen is 207g. The dried weight of the specimen is 163g. If the volume of the specimen is measured before drying is 110 cubic centimeter, determine the Bulk specific weight.
A compaction test was conducted in the laboratory and the following information was obtained: • The weight of the compacted soil specimen (including the mold) was determined to be 3815 • The volume of the mold = 1/30 ft³ (944 cm³) • The weight of the mold = 2050 g • The water content in the soil was determined to be 9.1% Find the dry unit weight of the soil (in units of kN/m³).
3- A series of standard Proctor compaction tests were performed on soil and the obtained results are presented in Figure below. The volume of the standard mould was 1 x 10³ m³ and Gs = 2.65. 1.82 1.80 1.78 1.76 What is the degree of saturation of the sample compacted to the maximum dry density? Estimate the volume of air (in m3) in the sample compacted to 15% water content. The void ratio of this soil in its loosest state is 1.74 1.72 1.70 1.68 1.66 0.623. Estimate the relative density of the soil sample compacted to 11% water content? 10 11 12 13 14 15 16 17 18 19 20 21 22 Water content (%) Dry density (g cm-3)
A dry sand is placed in a containerhaving a volume of 0.0089 cm3. The dry weight of the sample is 0.011 grams. Water is carefully added to the container so as not to be disturbthe condition of the sand. When the container is filled, the combined weight of the of soil plus water is 0.0144 grams. With this, find the moisture content, moist unit weight, dry unit wait, void ratio, the porosity, and degree of saturation. for a saturated soil show that; ????=(?/?)(1+?/1+?)??
Q.43 The liquid limit and plastic limit of a soil sample are 50% and 40% respectively. If the volumetric shrinkage at the liquid limit and plastic limit are 42% and 28%, then the shrinkage limit is %.
Permeability tests were performed on a soil sample, under different void ratio and different temperatures and the following results were obtained. Test No. 1 2 Void ratio (e) 0.65 1.02 Temperature °℃ 25° 40⁰ Estimate the coefficient of permeability at a temperature of 20°C for a voids ratio of 0.80. Given the following physical properties of water: At 20°C, n = 10.09 × 10+ and p„ = 0.998 g/cm³ At 25°C, n = 8.95 × 104 g sec/cm² and p k(cm/s) 0.4x10 1.9x10-¹ At 40° C, n = 6.54 × 10-¹ g sec/cm² and p $0.997 g/cm³ = = 0.992 g/cm³
A sample of clay was coated with paraffin wax and its mass, including the mass of wax, was found to be 697.5g. The sample was immersed in water and the volume of the water displaced was found to be 355 mL. The mass of the sample without the wax was 690g and the water content of the representative specimen was 18%. If specific gravity of soil solids and the wax is 2.7 and 0.89 respectively, solve for the degree of saturation.
A soil specimen weighs 30 grams oven dried. When mixed with 7.50 cc of water, the soil is at its plastic limit. The addition of another 10.50 cc of water brings the sample to the liquid limit. What is the plasticity index of the soil? Answer should be 10%.
Permeability tests were performed on a soil sample, under different void ratio and different temperatures and the following results were obtained. Test No. 1 2 Void ratio Temperature °C (e) 0.65 1.02 25° 40⁰ Estimate the coefficient of permeability at a temperature of 20°C for a voids ratio of 0.80. Given the following physical properties of water: At 20°C, n = 10.09 × 10+ and p„ = 0.998 g/cm³ At 25°C, n = 8.95 × 104 g sec/cm² and p k(cm/s) 0.4x10 1.9x10¹ At 40° C, n = 6.54 × 10 g sec/cm² and p 8 0.997 g/cm³ = 0.992 g/cm³