Calculate the power required by a system of one compressor serving two evaporators. One evaporator carries a load of 10 tons @ 10C and the other carries a load of 20 tons @ -10C. A back pressure valve reduces the pressure in the 10C evaporator to that of the -10C evaporator. The condensing temperature is 40 and the refrigerant is freon 22 What is the COP?

Calculate the power required by a system of one compressor serving two evaporators. One evaporator carries a load of 10 tons @ 10C and the other carries a load of 20 tons @ -10C. A back pressure valve reduces the pressure in the 10C evaporator to that of the -10C evaporator. The condensing temperature is 40 and the refrigerant is freon 22 What is the COP?

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter48: Cooling Towers And Pumps

Section: Chapter Questions

Problem 13RQ

See similar textbooks

Similar questions

The most popular refrigerant used in the past for residential air-conditioning is R- ________.
How is the refrigerant cylinder pressure kept above the system pressure when a system is being charged with vapor from a cylinder?
If the evaporating pressure was 76 psig for R-22 and the compressor inlet temperature was 65F, what would be the total superheat entering the compressor? A. 11F B. 21F C. 10F D. 20F
Most compressors are cooled using the ___________.
Two methods used to power refrigeration compressors on a ship are _____and ____.
Condensers in these refrigerators are all_______cooled.
The approach temperature for the evaporator is A. the difference between the suction and head pressures converted to temperature. B. the difference between the refrigerant boiling temperature and the suction-line temperature. C. the difference between the refrigerant boiling temperature and the inlet water temperature. D. the difference between the refrigerant boiling temperature and the leaving-water temperature.
In order to remove moisture from a refrigeration system using a vacuum pump, it must be in a _____state.
The compressor used in low-pressure chillers is the A. centrifugal. B. screw. C. rotary. D. reciprocating.
Calculate the power required by a system of one compressor serving two evaporators. One evaporator carries a load of 10 tons @ 10C and the other carries a load of 20 tons @ -10C. A back pressure valve reduces the pressure in the 10C evaporator to that of the -10C evaporator. The condensing temperature is 40 and the refrigerant is freon 22 What is the COP?
a standard vapor compression refrigeration system uses ammonia as refrigerant the amount of the evaporator negative 20 degrees centigrade on the condenser pressure is 1200 kpa. the flow rate is 30 kg/min. Determine a. the tons of refrigeration b. the power required c. the COP
With suitable block-diagram, compare vapour-compression and vapour-absorption refrigeration systems.