Consider an ideal gas with an absolute temperature of T₁. To what temperature would the gas need to be heated to double itspressure? Express the answer in terms of T₁.T₂ =Consider an ideal gas with a volume of V₁. To what volume would the gas need to be compressed to double its pressure?Express the answer in terms of V₁.V/₂=

Answer: Ideal gas equation: Pv=nRT Here: P=pressure of the gasV=volume of the gasn=number of moles…

Consider an ideal gas with an absolute temperature of T₁. To what temperature would the gas need to be heated to double its pressure? Express the answer in terms of T₁. 7₂ = Consider an ideal gas with a volume of V₁. To what volume would the gas need to be compressed to double its pressure? Express the answer in terms of V₁. V₂ =

Consider an ideal gas with an absolute temperature of T₁. To what temperature would the gas need to be heated to double its pressure? Express the answer in terms of T₁. 7₂ = Consider an ideal gas with a volume of V₁. To what volume would the gas need to be compressed to double its pressure? Express the answer in terms of V₁. V₂ =

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter5: Gases

Section: Chapter Questions

Problem 80QAP

See similar textbooks

Similar questions

A cylinder of compressed gas is labeled Composition (mole %): 4.5% H2S, 3.0% CO2, balance N2. The pressure gauge attached to the cylinder reads 46 atm. Calculate the partial pressure of each gas, in atmospheres, in the cylinder.
5-107 If 60.0 g of NH3 occupies 35.1 L under a pressure of 77.2 in. Hg, what is the temperature of the gas, in °C?
You have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
A four-liter tank is filled with propane gas, C3H8. The mass of the tank filled with gas is 1236 g. The pressure in the tank is 2.68 atm. The temperature in the room is 37C. The propane in the tank is used up under the same conditions of temperature and pressure. What is the mass of the empty tank?
Explain why the plot of PV for CO2 differs from that of an ideal gas.
109 An ore sample with a mass of 670 kg contains 27.7% magnesium carbonate, MgCO3. If all of the magnesium carbonate in this ore sample is decomposed to form carbon dioxide, describe how to determine what volume of CO2 is evolved during the process. What would have to be measured to predict the needed volume in advance?
Answer the following questions: (a) If XX behaved as an ideal gas, what would its graph of Z vs. P look like? (b) For most of this chapter, we performed calculations treating gases as ideal. Was this justified? (c) What is the effect of the volume of gas molecules on Z? Under what conditions is this effect small? When is it large? Explain using an appropriate diagram. (d) What is the effect of intermolecular attractions on the value of Z? Under what conditions is this effect small? When is it large? Explain using an appropriate diagram. (e) In general, under what temperature conditions would you expect Z to have the largest deviations from the Z for an ideal gas?