Consider the circuit in figure given below: A B The capacitor C is initially charged. At time 0, the switch is connected from A to B and the voltage across the capacitor is measured. The following data are recorded by a data acquisition system: (s) 0.0 0.1 0.2 0.3 0.4 0.5 V(V) 4.98 1.84 0.68 0.25 0.09 0.03 (a) Determine the linear correlation coefficient betweent and V. (b) Determine the linear correlation coefficient between t and In(V).

Consider the circuit in figure given below: A B The capacitor C is initially charged. At time 0, the switch is connected from A to B and the voltage across the capacitor is measured. The following data are recorded by a data acquisition system: (s) 0.0 0.1 0.2 0.3 0.4 0.5 V(V) 4.98 1.84 0.68 0.25 0.09 0.03 (a) Determine the linear correlation coefficient betweent and V. (b) Determine the linear correlation coefficient between t and In(V).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 500µs/cm and the volt/cm switch is on 5V/cm. The width of one complete cycle is 4cm and peak to peak height is 5cm. Find for the waveform a) the frequency, b) the peak to peak voltage, c) the amplitude, and d) the r.m.s value
Question A sinusoidal signal with a peak voltage of 10V is input into a frequency dependent circuit. What is the peak voltage at its -6dB frequency?
1. For the given circuit, sketch the waveform for Q. CIk D Clk
Fine the energy for the signal, please show steps and comment
please solve value of Capacitor with 0.1V Ripple. And draw output ripple waveform. Explain it one by one for me thanks..
Find the DC value and RMS value from this image in below. , I want the solution in a detailed picture with a white paper and a clear font. Thank you.
-) Below are two voltage patterns measured from an oscilloscope. The voltage stage of the CHI probe is 5 V / div, the CH2 probe voltage stage is 10 V / div and the time axis is 2ms / div. According to this information, a) What are the peak to peak and rms voltage values of the voltages in CHI and CH2? b) What is the frequency of the voltages in Hz? c) How many degrees is the phase difference between the two voltages, which voltage is leading?
Consider a square waveform with peak value 5A and time taken is 0.06s for 10 cycles. i. Sketch the approximate waveform and find frequency. ji. Determine the Form factor and peak factor.
what is polyphasic Ac waveforms with diagram
Q.B1 For the CRO square voltage waveform is shown in Figure. The 'time/cm' switch is on 50 ms/cm and the 'volts/cm' switch is on 5 V/cm. Calculate (a) the periodic time, (b) the peak voltage, (c) the time taken to complete half cycle. The periodic time is = The peak voltage is = The time taken to complete half cycle
If we assume the peak voltage Vmax across the capacitor is 16V and the capacitor discharges into the resistor for 12msec, what is the time constant (in milliseconds) of the circuit during the discharge?
Which of the following is true when an AC voltage is inputted to a diode then the voltage is measured across the load (the load is after the diode)? a. the input voltage is shifted by 60 deg. compared to the load voltage b. the two signals are in phase, but the load signal lacks the other half-wave c. the input voltage has twice the amplitude of the one across the load d. none of the choices e. the input voltage has a frequency double that of the load voltage