Determine and sketch the output voltage. R1 +10 V 1.0 kN D Vin 0- out 5 V -10 V Diodes are IN4001.

Q: Design a PLC program that will correctly execute the following industrial control process: A part is...

A: We need to draw and explain the PLC diagram for the given operation. The given operation and conditi...

Q: Pulse Amplitude Modulation, Pulse Position Modulation and Pulse Width Modulation are three methods o...

A: PWM The width of the pulse is varied depending on amplitude of Unmodulated signal.   PPM The positio...

Q: What is electrical machine.

A: Electrical Machine: It is a device that converts mechanical energy into electrical energy and vice v...

Q: What is the status of the diode with respect to the source voltage, what is the total current in the...

A: For Si diode, diode can be represented as voltage source of 0.7 V as shown in figure. We have to fi...

Q: Two balanced Y-connected loads in parallel, one drawing 15 kW at 0.6 power factor lagging and the ot...

A:

Q: What is a load break down simply?

A: Load Break - A load break circuit is a disconnected device that is meant to make or interrupt certai...

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a cap...

A:

Q: Given x(n) = {0,1,2,3, 4, 5, 6, 7} find x (k) using DIT FF T

A: As we know,  WNk=e-j2πNk And we know, the length of the FFT is 8. So, we will calculate : W80=e-j2π8...

Q: The pressure in a tank varies from 20 psi to 100 psi. Further pressure in the tank is desired to be ...

A: Given, The pressure in a tank varies from 20 psi to 100 psi. Desired pressure in the tank = 50 psi P...

Q: Assume the input signal to a rectifier circuit has a peak value of VM = 12 V and is at a frequency o...

A: The information given :   The peak value of VM=12 V The frequency f=60 Hz The output load resistance...

Q: 4. The open circuit voltage across the output terminals of an AC power supply is 15.2 V. When these ...

A:

Q: a) Answer all questions. 1. Which of the following is not an application of transmission line? a. Im...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Find the time function of the given Laplace Transform function. S 3 F(s) s² + 4 s² + 4

A: We need to find out inverse Laplace transform of given function

Q: Vour

A:

Q: Find the total impedance of the circuit below. -j5 N 5 Ω 3Ω 100/0° V(A) 5Ω j4 2 elll

A:

Q: phase relationships

A: A) FROM GIVEN RELATIONS WE CAN SAY THAT VOLTAGE V STARTS AT WT=-30 DEGREES AND CURRENT I STARTS AT W...

Q: Calculate the total impedance (Zin) in the circuit shown below. Assume the given frequency is 50 Hz ...

A:

Q: The FIR filter М-1 H(2) = h(n)z¯", n=0 is said to have an antisymmetric impulse response when h(n) =...

A: GIVEN: frequency response              H(z)=∑n=0M-1h(n)z-n FIND: (a) assuming that the filter length...

Q: Simplify the given to a + bi notation

A:

Q: Q1.Find the center and radius of the sphere x2 + y2 + z2 + 4x - 4z = 0? Q2. Find the angle bca of th...

A:

Q: An electron is situated between two plates 20 mm apart having a pd of 600 V between them

A:

Q: For the diode applied in the circuit has a knee current of 5mA, and a maximum allowed power dissipat...

A:

Q: The following information applies to the next two questions (questions 12 and 13). Two charges are l...

A:

Q: Given the electric network shown in the figure below, (a) write the differential equation for the ne...

A: The electric circuit diagram is shown below,

Q: Q2. Write KVL equation for circuit shown in Figure 6.

A:

Q: For the Circuit: Consider the load AB 29 1. Compute and show the equivalent Thevenin Circuit only. *...

A:

Q: A three-phase, 4-pole, 1,500 rpm alternating having a double layer-windings with 18 turns per coil. ...

A:

Q: Two units are connected in parallel , are energized by an AC source. If the components are 10 and 14...

A:

Q: Find the total current of the circuit below. -j5 N 5Ω 3Ω 100/0° V(A, 5Ω j4 N O 55/29 - j80/29 A O 22...

A:

Q: L ll R2 ww ei R1 For the given electrical circuit write down equations of motionį ww

A:

Q: Apşliauees | . Daily Total use perhou Watt Total Cost ( in Kwh) No. of D Ceiling Applinues fom 7o w ...

A:

Q: 30 Q 25 Q 10 Q 20 Ω a o 15 N bo

A:

Q: 1. The value of i, in the circuit below is ImA for t 0, Find v,(t) for (a) t0 1 kQ 0.1 H 10 kΩ 20 nF...

A:

Q: benefits of organic light-emitting diode (OLED) screens over LCD panels

A: THE BENEFITS OF OLED OVER LCD ARE 1)LOW POWER CONSUMPTION THE OLED CONSUMES LESS POWER COMPARED TO L...

Q: Upload answer sheets i) With a neat sketch explain the construction and operation of a Moving coil i...

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: How to make the bridge output (Vo) equal to zero? explain? 2- Write some applications for the Strain...

A: Without a section on bridge circuits, no text on electrical metering would be complete. These clever...

Q: 1. A building, supplied by a public utility, contains three balanced loads connected to the three-ph...

A: SOLUTION:-      V3-ϕ =4.16 KV  ,                 V1-ϕ =4.16K3=2.402KVSdelta = 500KVA ,0.85 lag  ;   ...

Q: is te) - 5 cosfi00t +40] 0-18 FIMF 200

A:

Q: A DC series generator delivers a load of 20 kW at 400 V. The armature and field resistances are 0.3 ...

A: A DC generator is an electrical device used to produce current. The primary function of this device ...

Q: 2. Draw and label the Thévenin equivalent circuit that represents the circuit shown below, as seen f...

A:

Q: Apply Nodal Analysis in determining the values of Va, Vb, and Vc on the circuit below. 1 A 12 2iy 5i...

A:

Q: 2. Given the points P(4,7,3) and Q(-3,6, –5) a. Locate P in cylindrical coordinates b. Locate P in s...

A:

Q: Find the total current of the circuit below. -j5 N 5Ω { 32 3Ω 100/0° V(A 5Ω j4 2 +1

A:

Q: 1.What type of transformers do we use to send power out to our power grid? A. Step Up Transformers. ...

A: In power stations to produce the high voltage required to transmit electricity through the Power gri...

Q: Find out the Laplace Transform of the following function: z(1) = e'u(1) -551

A: In this case, the Laplace transform of the following function needs to be determined: zt=e-55tut

Q: Given the following circuit determine: a. The bandwidth. b. Draw BODE plot. 20 V C = 6 pF Che = 20 p...

A: Given the circuit, as shown below: a) We need to find the bandwidth. b) We need to draw the bode pl...

Q: integrated circuit

A: an integrated circuit is a semiconductor(electronic) circuit formed by using semiconductor of small ...

Q: 8 A 12 V 103 0 V

A:

Q: On a three phase system with voltages greater than 600V the typical color used to designate phase Z(...

A: ORANGE COLOR

Q: Two wires A & B made from two different materials have temperature coefficient of resistance equal t...

A: GIVEN:              αA=0.0025Ω/°CαB=0.0005Ω/°CRT=1200ΩαT=0.001Ω/°C FIND: length of wire A

Digital to Analog Converters

Digital to analog converters are commonly known as DAC, digital analog converter, D2A, or Digital-to-Analog converters. DACs are one of the important devices used in the electronics and electrical domain. DACs are the systems that convert a digital signal into an analog signal, whereas an analog to digital converter or ADC performs the opposite function. Digital signals are those signals that can represent the information or data as a set of discrete values. At a particular instant of time, a digital signal can only take a particular value of data. A digital signal is characterized by two unique values; zeros and ones, or true and false, represented by the Boolean domain. These are also known as binary signals or logic signals. Unlike digital signals, an analog signal is represented by continuous values, where at any time instant, the analog signal is represented by a real number.