Grams of solute /100 g H,0 Suppose 100 g of NaNO, 60°C. Using the solubility curves below, which term best 3 is dissolved in 100 g of water at describes this solution? Solubility Curves 150 140 KI 130 120 NANO, KNO 110 100 90 80 HC 70 NH.CI 60 KCI NH3 50 40 NaCI 30 KCIO 20 10 SO 10 20 30 40 50 60 70 80 90 100

Grams of solute /100 g H,0 Suppose 100 g of NaNO, 60°C. Using the solubility curves below, which term best 3 is dissolved in 100 g of water at describes this solution? Solubility Curves 150 140 KI 130 120 NANO, KNO 110 100 90 80 HC 70 NH.CI 60 KCI NH3 50 40 NaCI 30 KCIO 20 10 SO 10 20 30 40 50 60 70 80 90 100

General, Organic, and Biological Chemistry

7th Edition

ISBN:9781285853918

Author:H. Stephen Stoker

Publisher:H. Stephen Stoker

Chapter8: Solutions

Section: Chapter Questions

Problem 8.29EP: A compound has a solubility in water of 250 mg/L at 25C. Should this compound be characterized as a...

See similar textbooks

Similar questions

Sodium chloride (NaCl) is commonly used to melt ice on roads during the winter. Calcium chloride (CaCl2) is sometimes used for this purpose too. Let us compare the effectiveness of equal masses of these two compounds in lowering the freezing point of water, by calculating the freezing point depression of solutions containing 200. g of each salt in 1.00 kg of water. (An advantage of CaCl2 is that it acts more quickly because it is hygroscopic, that is. it absorbs moisture from the air to give a solution and begin the process. A disadvantage is that this compound is more costly.)
A compound has a solubility in water of 250 mg/L at 25C. Should this compound be characterized as a soluble or insoluble compound at 25C?
The freezing point of 0.10 M KHSO3 is -0.38C. Which of the following equations best represents what happens when KHSO3 dissolves in water? (a) KHSO3(s)KHSO3(aq) (b) KHSO3(s) K+(aq)+HSO3(aq) (c) KHSO3(s) K+(aq)+SO32(aq)+ H+(aq)
The dispersed phase of a certain colloidal dispersion consists of spheres of diameter 1.0 102 nm. (a) What are the volume (V=43r2) and surface area (A = r2) of each sphere? (b) How many spheres are required to give a total volume of 1.0 cm3? What is the total surface area of these spheres in square meters?
Common commercial acids and bases are aqueous solutions with the following properties: Density (g/cm3) Mass Percent of Solute Hydrochloric acid 1.19 38 Nitric acid 1.42 70. Sulfuric acid 1.84 95 Acetic acid 1.05 99 Ammonia 0.95 28 Calculate the molarity, molality, and mole fraction of each of the preceding reagents.
A gaseous solute dissolves in water. The solution process has H=15 kJ. Its solubility at 22C and 6.00 atm is 0.0300 M. Would you expect the solubility to be greater or less at (a) 22C and 1 atm? (a) 18C and 6 atm? (a) 15C and 10 atm? (a) 35C and 3 atm?
The Henry's law constant for the solubility of argon gas in water is 1.0103M/atm at 30C. (a) Express the constant in M/mm Hg. (b) If the partial pressure of argon gas at 30C is 693 mm Hg, what is the concentration (in M) of the dissolved argon gas at 30C? (c) How many grams of argon gas can be dissolved in 29 L of water at 693 mm Hg and 30C? (Ignore the partial pressure of water.)
A patient has a “cholesterol count” of 214. Like manyblood-chemistry measurements,this result is measured inunits of milligrams per deciliter (mgdL1). Determine the molar concentration of cholesterol inthis patient’s blood, taking the molar mass of cholesterolto be 386.64gmol1. Estimate the molality of cholesterol in the patient’sblood. If 214 is a typical cholesterol reading among men inthe United States, determine the volume of such bloodrequired to furnish 8.10 g of cholesterol.
Specifications for lactated Ringers solution, which is used for intravenous (IV) injections, are as follows to reach 100. mL of solution: 285315 mg Na+ 14.117.3 mg K+ 4.9Q.O mg Ca2+ 368408 mg Cl 231261 mg lactate, C3H5O3 a. Specify the amount of NaCl, KCl, CaCl2 2H2O, and NaC3H5O3 needed to prepare 100. mL lactated Ringers solution. b. What is the range of the osmotic pressure of the solution at 37C, given the preceding specifications?
Solutions Introduced directly into the bloodstream have to be isotonic with blood; that is, they must have the same osmotic pressure as blood. An aqueous NaCl solution has to be 0.90% by mass to be isotonic with blood. What is the molarity of the sodium ions in solution? Take the density of the solution to be 1.00 g/mL.
How do colloids differ from solutions with regard to dispersed particle size and homogeneity?