In the Analytical Chemistry laboratory, one of the B.Sc student Ms. Fatma wanted to analyze the presence of Iron(II) ion in the water samples collected from Sohar Industrial Area in the Sultanate of Oman and analyzed by Spectrophotometric method. 250.00 mL of this water sample (Solution A) known to contain unknown amount of FeSO4. She has diluted Solution A by a dilution factor 10 to make 250.00 mL solution, which she labeled Solution B. Using Spectrophotometer, she has measured the absorbance value (0.642) for Solution B at 508 nm using 1.00 cm cell (cuvet). The molar absorptivity value for Fe2* ion at 508 nm is ɛ508 = 30.8 M-1cm-1. (i) What volume of the solution A did she require to make the 250.00 mL of Solution В? (ii) in (i)? What instrument should she use to transfer the volume of the Solution A calculated (ii) Concentration of FeSO4 in Solution B. (iv) Concentration of FeSO4 in Solution A. Mass of FeSO4 in Solution A (Show your calculation) (v)

In the Analytical Chemistry laboratory, one of the B.Sc student Ms. Fatma wanted to analyze the presence of Iron(II) ion in the water samples collected from Sohar Industrial Area in the Sultanate of Oman and analyzed by Spectrophotometric method. 250.00 mL of this water sample (Solution A) known to contain unknown amount of FeSO4. She has diluted Solution A by a dilution factor 10 to make 250.00 mL solution, which she labeled Solution B. Using Spectrophotometer, she has measured the absorbance value (0.642) for Solution B at 508 nm using 1.00 cm cell (cuvet). The molar absorptivity value for Fe2* ion at 508 nm is ɛ508 = 30.8 M-1cm-1. (i) What volume of the solution A did she require to make the 250.00 mL of Solution В? (ii) in (i)? What instrument should she use to transfer the volume of the Solution A calculated (ii) Concentration of FeSO4 in Solution B. (iv) Concentration of FeSO4 in Solution A. Mass of FeSO4 in Solution A (Show your calculation) (v)

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter12: Solutions

Section: Chapter Questions

Problem 12.107QE

See similar textbooks

Similar questions

You were assigned to assay a product sample of milk of magnesia. A 0.600-g sample was reacted with 25.00 mL 0.10590 N H2SO4 . The excess unreacted acid in the solution required 13.00 mL of 0.09500 N NaOH when titrated to reach the methyl red end point. Determine the dosage strength of the product in terms of % Mg(OH)2 content. Type your answer in 2 decimal places, numbers only.
1. (a) A solution of NaCl is prepared by dissolving 0.0056 g NaCl with enough H2O in a volumetric flask to yield a final volume of 10 mL. Assuming a standard (0.1 mg) analytical balance and class A glassware is employed, calculate the concentration of the solution (M) and its corresponding error. The atomic weights of Na and Cl are 22.98976928(2) and 34.45(1), respectively (the number in parentheses indicating the error in the last digit). (b) What would the error be if a 1mL transfer pipet was employed (10x) rather than the 10 mL volumetric flask?
A 1.407 g sample of canned tuna was analyzed by the Kjeldahl method. The liberated NH3 required 26.45 mL of 0.1180 M HCl. Calculate the percentage nitrogen and protein in the sample. Assume that the protein factor is 6.25, i.e. % protein = % N x 6.25.
A new analytic instrument is capable of detecting picogram quantities of a chemi-cal substance. How many times more capable is this instrument than one that candetect nanogram quantities of the same chemical?
A student creates a calibration plot for serial dilutions of Cu(NO3)2. A graph of concentration in M (x-axis) versus absorbance (y-axis) gives a linear trendline of y = 0.345x - 0.11. e.) Copper(II) nitrate has a solubility of 83.5 g in 100 g of water. Calculate the percent error in the student's concentration.
13. Mg(OH),(s) + 2HC{aq) → M9CL(aq) + 2H,0(1) The student found that 32.00 cm3 of 0 500moldm-3 HCIas needed to react with the Mg(OH2 in a 500 mg tablet. [1g = 1000 mg]. (i) Calculate the amount, in mol, of HCL used. amount = mol (i) Determine the amount, in mol, of Mg(OH), present in the tablet. amount = mol (iii) Determine the percentage by mass of Mg(OH), present in the tablet. answer = A carried out an to find by mass of in an (d) sell tablets to indigestion. indigestion tablet. The student reacted the tablet with dilute acid.
2. The analytical ability of two lab technicians was compared by having each perform analyses for arsenic using the same method on samples having the same origin. For analyst A, s.d. = 0.12%, N=6; and for analyst B, s.d. = 0.06%, N-5. Do these results suggest a difference in the precision of the two chemists?
A colored solution of concentration 0.0344 mol/L has an absorbance of 0.481. What is the concentration a solution of the same solute with an absorbance of 0.651? Assume that the same sample celf is used for both readings. Report your answer to 3 significant figures.
Answer 7c
(2) In the Analytical Chemistry Laboratory Mr.Yahiya Al Moqbali wanted to prepare KCI solution. He has dissolved 2.634 (+0.002) g of KCI in a 250.00 (±0.08) mL volumetric flask. Calculate the molarity of the solution and express your answer with its absolute uncertainty and give reasonable number of significant figure. [The formula mass of KCI is 74.5513 (±0.001) amu] (Show your Calculation)
You are preparing a 100.0 mL standard solution needed for titration analysis. The NaOH (40 g/mol) pellets are measured to be 0.5341 g in a balance with acceptable uncertainty of +0.001 g. Mass of the pellets is recorded after taring the container. The pellets are put in a beaker and added with 50 ml distilled water measured by a graduated cylinder. The solution is then quantitatively transferred to a 100-mL volumetric flask with uncertainty of ±0.08 mL and diluted to a 100-mL mark. What is the concentration (M) of the solution and estimate its uncertainty by propagation? Assumption: There is no uncertainty in molar mass. Express your answer as C+/- u M.
can be used as a standard solution for checking the concentration of a solution containing sulphuric acid, 8.7 cm' of sulphuric acid. Find the concentration of the sulphuric acid in both mol dm3 and g dm³. In a particular experiment 10,0 cm³ of a 0.50 mol dm³ solution of sodium ethanedioate was found to react with Q2. Sodium ethanedioate, Na;C¿O4, can be made into a solution of an exact and reliable concentration and so London ndon A.C.1.2