نقطة في حدة =By using Karnaugh Map (K-map) shown below, F CD AB 00 01 11 10 00 1 01 11 10 BCD+ĀCD BCD+ BCD ĀC + ACD AC+ABD 1. 1.
Q: Nyquist rate for x(t) = 4cos(4000rt)sin(4000t) Your answer
A: The answer is given below
Q: Using the line coding techniques, draw the waveform of the data 01001100011 In Manchester encoding…
A: Image attached showing the waveforrm of Manchester line technique Symbols are given at the top of…
Q: Q 6 b) Convert the following NFA to DFA. State b a →q0 q1 *q2 q0, q1 q2 q1 q1, q2 -- -- 90 q2 q1
A: Conversion of NFA with epsilon to DFA Transition table Transition Diagram
Q: The Nyquist formula gives us any signal level while Shannon capacity gives us the Upper Limit…
A: Nyquist Formula:- Using calculation of the bit rate directly from the number of signal levels and…
Q: P5.7 Use Karnaugh map to reduce the following Boolean expression then draw the digital circuits for…
A: Step 1:- Use the 3 variable k-Map:-
Q: Transformation is given by f (n) = - n and simply involves "flipping" the signal x(n) with respect…
A: The given question regarding transformation:
Q: Perform correlation on the two signals x[n] and y[n] Y 1 3 3 -2 2 -1 3 4 O 25 35 O 55 45 3. 1. 3. 1.…
A: Answer : Given Data - For X values are (1,3,-2,4). For Y values are (2,3,-1,3)
Q: Compute the DTFT of the following signals: i) x[n] =[ ii) x[n] = [1, -2, 1]
A: Here is the detailed explanation of the solution
Q: x(t)=cos(w t), Is it periodic signal?
A:
Q: Q6/Chose the correct answer for the output Q3 of the following circuit ( Assume that A= 1010101010,…
A: The correct answer for the above question is given in the below steps.
Q: t < 0} f(t) te Calculate the laplas transform of the signals given below.
A: The laplas transform of the signals
Q: The Nyquist sampling rate is a. f b. 2f c. 4f d. 6f
A: Given that: The Nyquist sampling rate is a. f b. 2f c. 4f d. 6f
Q: Simplify the following three K-Amps and draw the final simplified circuit. Use either Tina or…
A: Given, Kmap is : There are 3 octets which can be obtained from the above kmap. 1st octet = A '…
Q: 2) Given P=110011 and M=11100011, use CRC technique to find FCS and transmitted frame. Note: FCS is…
A: As per our guidelines, only one question will be answered. So, please repost the remaining questions…
Q: onvert these rules to CNF. A → ABA| B|a|ab B→BCB|C|b|bc|e C→CD|DC|c D→D E
A: Given :- A -> ABA | B | a | ab B -> BCB | C | b | bc | epsilon C -> CD | DC | c D ->…
Q: A (7,4) block code has the parity check matrix as: 11 0 1 1 0 01 H = 11 10010 1111 00 1] This code…
A: please see the next step for solution
Q: Which one of the following is the function of the given circuit ? ABC )Q = (a+b') + bc + ( b'+c')'…
A: The Expression is Q = ((ab')'+bc'+(b'+c')')'
Q: Find the minimum SoP expression corresponding to the below K-map: | 00 01 11 AB 10 CD 00 1 1 01 1 11…
A: Answer: b) F = AIB + AICIDI + ABIC + ACID Explanation: To find the minimum Sum of Products we have…
Q: For a resolution of 0.032 V and an analog sample voltage of 4.030 V, complete the table below:…
A: Below I have provided the handwritten solution of the given question
Q: Drag and drop the missing terms into the corresponding minimum SOPS of the following K-map: AB 00 01…
A: Output F = A'C + CD + BD + BC + AC' By using K map of the given expression 1. F=A'C +BD+AC'+AD+BC 2.…
Q: Given the generator matrix 1 1 O 0 0 0 0 1 1 1 O O B 1 0 0 1 O 183 1 0 0 0 1 (a) Find H the…
A:
Q: b. Create your own function that runs the DTET algorithm and returns coefficients of the Fourier…
A:
Q: 2. Plot at least two cycles of the following periodic signal: x, (1) = jelo«
A: Requirements:- Plot on Matlab only on 2d with the imaginary axis on y side and real on x side
Q: value for correlation coefficient for two signals means they are less similar A O large O zero Small…
A: positive correlation :- it is for two signals both signal are in the same direction. when one signal…
Q: Translate the following into GPLI: (iv) If everyone else is in Paris, then so are Alice and Bob..
A: Note: As per the note in the question, we are not supposed to take any statement about what Alice…
Q: x[n+N]=x[n] is defined the __________________________signal
A: A discrete time signal is periodic if there is a non-zero integer.
Q: Q5 For a LBC has generator matrix [G]: 1 0 1 0 0 001101100 0 1 1 0 1 G= 0 1 0 0 1 1 0 1 1 0 lo 0 1 0…
A: According to the information given:- We have to generate LBC matrix G.
Q: write a Matlab program to simulate the following signal by selecting a proper sampling frequency…
A: please check the step 2 for solution
Q: 2. Plot at least two cycles of the following periodic signal: XG (1) = je10«
A: Do it in matlab
Q: Plot the following signals. Label x-axis with time(s) for continuous time signals, and 'n' for…
A: Matlab code: clc; clear all; % clear all the registers close all; % it will closes all previous…
Q: H.W. 1 Find the Nyquist rate and Nyquist interval for the following signals: 1. m(t)…
A: Answer 1
Q: t=0:0.01:10%3; f1%-sin(10*t); f3=1/3*sin(30*t); f5=3; f7=; Complete the matlab code to demonstrate…
A: t=0:0.01:10; f1=sin(10*t); f3=1/3*sin(30*t); f5=1/50*sin(50*t); f7=1/70*sin(70*t);…
Q: type ard using an illustration. 100 ADD R1, R2 101 OR R3,R2.R1 102 Jump 107 103 SW R 104 Jump 106…
A: It is defined as a low-level language because it directly works with the internal structure of CPU.…
Q: b- What is the minimum sampling frequency in hertz for the following signal x(t)=sin(4041t).
A: ANSWER : The minimum sampling frequency in hertz for the following signal x(t)=sin(4041t) is : fs =…
Q: Plot the following signals. Label x-axis with time(s) for continuous time signals, and 'n' for…
A: Matlab code: clc; clear all; % clear all the registers we have close all; % it will closes all the…
Q: H.w/ find the 0/p of PCM for i/p signal x(t) the sampling frequency 5 kHz for 0<t< 0.1 s and eight…
A: Please find the attached solution belowIf you dont understand anything please do commentAll the Best
Q: Discretize the following continuous-time signal at an appropriate sampling rate, and then plot he…
A: According to the question we have to plot discretized version of the equation: here, I'm using…
Q: Assume we want to find the best match between an EEG signal and a sinusoidal waveform. EEG sample…
A: The mоst соmmоn wаy оsсillаtiоns аre used tо сhаrасterize brаin асtivity is by using…
Q: Q3] A discrete memoryless source emits the following alphabet symbols: M1 -M2 M3 -M4 -M5 -M6 0.3…
A: The sum of probabilities must be equal to 1. therefore- M1+M2+ M3 +M4 +M5 +M6=10.3 +0.25 +0.2…
Q: Compute the energy of the signal x(t) = 2cos(nt) in one period time and also compute the average…
A: t=(0:1); % one time period x_t=2*cos(pi*t); % given signal Energy = norm(x_t,2)^2 % the energy of…
Q: Determine if the signal x(t) is an energy or power signal by finding the value of the energy or…
A: Solution
Q: 010"llAsiacell In an FM broadcast the maximum * :permitted audio frequency is 15 KHz O 75 KHz O 25…
A: FM radio uses frequency modulation, obviously. The frequency band for FM radio is around 88 to 108…
Q: _______ data have discrete states and take discrete values. a. Analog b. Digital c. (a) or (b)
A: Analog is continuous in state and will never have discrete values.
Q: Given that A=0, B=0, C=1, what are the values of F an Y in the following circuit? (3 Points) A D D,…
A: Since A=0 B=0 and C=1 When we pass throw mux it will high f=1
Q: Draw the ASK signal? Q2: write a Matlab code to simulate a ASK modulation signal only. A. generate…
A: Solution: ASK signal: Amplitude Shift Keying It is a type of Amplitude Modulation which represents…
Q: Q6/Chose the correct answer for the output Q3 of the following circuit ( Assume that A= 1010101010,…
A: Answer: The correct answer for the output Q3 of the following circuit where A = 1010101010 B=…
Q: Question 1: Consider the following 8-way multiplexer. Write F(a,b,c) as sum of minterms. 000 00 1 0…
A: Pin A B C f 0 0 0 0 0 1 0 0 1 1 2 0 1 0 0 3 0 1 1 0 4 1 0 0 1 5 1 0 1 1 6 1 1 0 0 7…
Q: Choose the most simple SOP expression from the K-map shown. AB 00 01 11 10 00 1 01 CD 11 10 Select…
A: EXPLANATION: The k-map minimizes the boolean expression on the basis of the groups that are formed…
Q: Given that A=0, B=0, C=1, what are the values of F an Y in the following circuit? Do D D2 3X8 D Low…
A: A=0 and B=0 and c=1 Decoder do high D1 And everything is 0 and D1 is high When we pass this logic…
Q: LA signal x(n) is graphically shown below. Show the graphical representation of the signals -3x(n')…
A: From the given graph, we can observe that, x(n) = 4+nfor n < 04for 0≤n≤40for 4 < n
Step by step
Solved in 2 steps with 1 images
- Optimize the given atomic sequence for ((a + b) + c) / (a + b + c)-(a + b + c) with DAG.Simplify the following boolean expressions, using k-maps ABCD+ACD+BCD+ABCD+BCD wyz+wx+wxzGenerate a RAC parity matrix for a (20, 12) coding of the data word 111001010001. Use the grid shown below (or a similar one). Explain your work. What are the limitations of this technique?
- Simplify the Boolean expression [AB(C + BD) + ABJCD.3. Use the Karnaugh-Map to simplify the following expressions F(A, B, C) = ABC + ABC + ABC + ABC + ABC F(A,B,C,D) = A + AB + ABC + BCD + ACD ii.7. Find the forward shift row transformation of the following blocks: 61 1A DF 8A BA C5 34 ID 44 1A 40 C2 22 11 41 29 (ii) BI 1C 56 92 25 81 AA 23 54 54 B9 1F АВ 45 D4 F2