Q) When the patient is unconscious, the specialized doctor gives him nutrients through an intravenous solution, the density of which is 1.05 g/ml, through a vein in the arm. If the intravenous pressure gauge is 5.980 KPa, what is the minimum height that will allow the solution to enter the patient's vein? (Suppose that the viscosity of the solution is neglected). Ground acceleration m/s2 9.81

Q) When the patient is unconscious, the specialized doctor gives him nutrients through an intravenous solution, the density of which is 1.05 g/ml, through a vein in the arm. If the intravenous pressure gauge is 5.980 KPa, what is the minimum height that will allow the solution to enter the patient's vein? (Suppose that the viscosity of the solution is neglected). Ground acceleration m/s2 9.81

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

4. If the modulus of elasticity (E) for water is given to be 2.2GPa, what pressure is required to reduce the volume by 0.6%? 5. A tank contains two substance oil (A) and water (B) subject to variable air pressure: the dimension is shown below and corresponds to 1atm If air is
58.27 cm Determine the shear stress acting on the fluid element for a velocity profile of 5*y+1 and viscosity of 0.25 kg/(m*sec) by using Newton's law of viscosity? 5 Pa 0.25 Pa none 2.25 Pa 1.25 Pa 1 bar pressure difference is equal to .. water manometer height. Take water specific gravity as 1 O O O
1. 1) The acceleration of a particle moving along a straight line is a = (-C· /v) m/s², where C is a constant and vis velocity in m/s. If the constant Cis 1.5, and the initial velocity vo = 6.9 m/s at time t= 0, determine how far (in m) it has traveled when it stops. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point.
1. The density of an oil is 850 kg/m3. Find its relative density (or specific gravity) and Kinematic viscosity if the dynamic viscosity is 5 x 10-3 kg/ms. 2. If the viscosity of water at 70 °C is 0.00402 poise and its specific gravity is 0.978 determine its absolute viscosity in Pa-s and its kinematic viscosity in m²/s and in stokes 3. Calculate the Reynolds number, Re for water flow in a circular pipe. The diameter of the pipe is 50 mm, the density of water is 998 kg/m³, the volumetric oil flowrate is 720 L/min, and the dynamic viscosity of water is 1.2 centipoise
Dynamic viscosity of fluid Density of fluid If X= , then the unit of X is = O m?/kg O m/sec? O m/sec O m?/sec The container contains an oil of specific gravity 0.64 with the pressure measured at the bottom of the container is 150 Pa. Find the pressure head in m of oil. The pressure head of oil in m = If the density of fluid is not a variable in a fluid flow, it is known as O Incompressible O Unsteady flow O Uniform flow O Compressible
Q) The velocity v (m/s) of air flowing past a flat surface is measured at several distances y(m) away from the surface. Use Newton'sviscosity law to determine the shear stress t (N/m³) at the surface (y=0). dv 'dy Assume a value of dynamic viscosity =1.8* 10- N.s/hm² y, m V, m/s 0.002 0.287 0.006 0.899 0.012 |1.915 0.018 3.048 0.024 4.299 (r-7) Use two forward đifference approximations for h=0.006. Estimate the approximate percent relative error, &. b- , (t=?) Use two forward difference approximations with a step size of 0.012 (h=0.012). Estimate the approximatepercent relative error, , e.. (r-?) ApplyRichardson extrapolation. Estimate the approximate percent relative error, & (r=?) Use unequally spaced three data and the first-derivative of a second-order d- Langrange polynomial to evaluate the derivative (y=0) and shear stress. Estimate the approximate percent relative error, Eg Compare the approximate estimates of the error ([ed ) for the formulas used.
The Reynold's number of a sphere falling in air is 1E6. If the sphere's radius is 1ft, what is its velocity? Density of air is 0.00234 slug/ft³ and viscosity of air is 3.8E-7 lbf-sec/ft²A. 2.5 ft/sB. 5.1 ft/sC. 40.6 ft/sD. 81.2 ft/s
valg, (21535mm 1.15 The pressure difference, Ap, across a partial blockage in an artery (called a stenosis) is approximated by the equation μV Ap - K. 4 + K.(A-1) pv² = K₂ A s.r to zogy nish190 32\V as bonb dignol a 3 basiy noft where V is the blood velocity, u the blood viscosity (FL-2T), p the blood density (ML), D the artery diameter, Ao the area of the unobstructed artery, and A, the area of the stenosis. Determine the dimensions of the constants K, and K. Would this equation be valid in any system of units?
fluıd mechanıcs Values for a fluid flowing in a circular pipe are given in the table.a) by writing Newton's law of viscosity,b) Determine the flow behavior of the fluids, show on the graph that they obey the Newtonian or non-Newtonian flow behavior. Calculate the dynamic viscosity values on the graph.c) If the viscosity of the liquid is 0.121 g/cm3, calculate the kinematic viscosity and convert it to the English Unit system.
3 kN/m 2 m 4 m What is the equation of dy,/dx,? -0.5x23 + 3.75x,² -6x2 + C3 + C4 -0.5x,3 + 3.75x,2 - 6x2 + C3 -1.5x,3 + 3.75x,² -6x2 + C3 D -0.5x,3 + 3.75x,2 -6x2
Choose the correct answer Kinematic viscosity is * f. dynamic viscosity* Density b. About 1.2*10^-2 m2/s for water e. Both b and d c. Density*dynamic viscosity d. Both a and c g. Both f and c a. About 1.2*10^-6 m2/s for water
Consider the portion of an excavator shown. At the instant under consideration, the hydraulic cylinder is extending at a rate of 6 in./sec, which is decreasing at the rate of 3 in./secevery second. Simultaneously, the cylinder is rotating about a horizontal axis through O at a constant rate of 12 deg/sec. Determine the velocity vand acceleration a of the clevis attachment at B. B 2.7 3.6' 370 Part 1 Correct Determine the indicated terms used in the velocity and acceleration formulas. B 2.7' 3.6' 37° Answers: r- 75.6 in. 37 in./sec 9 - 0.21 rad/s -3 in/sec? 0 - rad/s?