Question 3 The work done for a thermodynamic process can be calculated using the tabulated data and the equation below: W = Table 1: Pressure vs Volume Data S PdV where W is work done, P is pressure, and V is the volume. Use Trapezoidal method (Do it by hand and show all calculations) and built-in trapz function to estimate the total Work done, in kJ.

Question 3 The work done for a thermodynamic process can be calculated using the tabulated data and the equation below: W = Table 1: Pressure vs Volume Data S PdV where W is work done, P is pressure, and V is the volume. Use Trapezoidal method (Do it by hand and show all calculations) and built-in trapz function to estimate the total Work done, in kJ.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q8): To find how much heat is required to bring a kettle of water to its boiling point, you are asked to calculate the specific heat of water at 61°C. The specific heat of water is given as a function of time in Table below. Temperature, T Specific heat, C₂ (°C) J kg-°C 22 42 52 82 100 4181 4179 4186 4199 4217 Determine the value of the specific heat at 7=61°C using the direct T method of interpolation and a third order polynomial. Find the absolute relative approximate error for the third order polynomial approximation (Lagrange Method).
Q(2) Complete the blank cells in the following table of properties of steam. In the last column describe the condition of steam as compressed liquid, saturated mixture, superheated vapor, or insufficient information; and, if applicable, give the quality. Р (кра) T ('C) v, m'/kg u, KJ/Kg Phase description 300 35 130.24 313.22 135 600 1.34139 275 0.500 600 3090
is a mass hanging by a spring under the influence of gravity. The force due to gravity, Fg, is acting in the negative-y direction. The dynamic variable is y. On the left, the system is shown without spring deflection. On the right, at the beginning of an experiment, the mass is pushed upward (positive-y direction) by an amount y₁. The gravitational constant g, is 9.81 m/s². DO C.D Frontly у Your tasks: No Deflection m k Fg = mg Initial Condition y m k Write down an expression for the total energy If as the sum Write down an expression for the total energy H Fg = mg Figure 3: System schematic for Problem 4. Yi & X Write down, in terms of the variables given, the total potential energy stored in the system when it is held in the initial condition, relative to the system with no deflection. as the sum of potential and kinetic energy in terms of y, y, yi C After the system is released, it will start to move. Write down an expression for the kinetic energy of the system, T, in terms of…
The following table lists temperatures and specific volumes of water vapor at two pressures: p = 1.5 MPa v(m³/kg) p = 1.0 MPa T ("C) v(m³/kg) T ("C) 200 0.2060 200 0.1325 240 280 0.2275 0.2480 240 280 0.1483 0.1627 Data encountered in solving problems often do not fall exactly on the grid of values provided by property tables, and linear interpolation between adjacent table entries becomes necessary. Using the data provided here, estimate i. the specific volume at T= 240 °Č, p = 1.25 MPa, in m/kg ii. the temperature at p = 1.5 MPa, v = 0.1555 m/kg, in °C ii. the specific volume at T = 220 °C, p = 1.4 MPa, in m'/kg
is a mass hanging by a spring under the influence of gravity. The force due to gravity, Fg, is acting in the negative-y direction. The dynamic variable is y. On the left, the system is shown without spring deflection. On the right, at the beginning of an experiment, the mass is pushed upward (positive-y direction) by an amount y₁. The gravitational constant g, is 9.81 m/s². No Deflection m k Fg = mg Initial Condition m k Fg = mg Figure 3: System schematic for Problem 4. Yi 8 Your tasks: A Write down, in terms of the variables given, the total potential energy stored in the system when it is held in the initial condition, relative to the system with no deflection. B Write down an expression for the total energy H as the sum of potential and kinetic energy in terms of y, y, yi and element parameters. Will H change as the mass moves? C After the system is released, it will start to move. Write down an expression for the kinetic energy of the system, T, in terms of position, y, the initial…
Time left 1:5 An ideal gas has its pressure (1.8) times and mass density (2.2) times increased. If the initial temperature is 265.4 °C, what is the final temperature in °C, and use one number after the decimal (xxx.x)? Answer: NEXT PAGE pe here to search DELL
For a venturi meter given below, the volumetric flow rate is defined in terms of the geometrical parameters, the density of working fluid (p), and density of the manometer liquid (pm) as 4. Q = f(D, D2, A2, g, h, Pmv Pr) %3D Write down the balance equations and show your work to end up with an expression for the volumetric flow rate in terms of the variables defined above.
Energy of a Roller Coaster Car 500 450 400 350 --- 3 300 250 E 200 150 100 50 6 8 10 Time (s) Mechanical Energy ....... Potential Energy -- Kinetic Energy This graph shows different types of energy for a roller coaster car that starts at the top of a large hill and goes down to its lowest point at 6 s. According to the graph, what is the most likely relationship between height and potential energy? Your answer: They are directly related. They are inversely related. There is no relationship between the two. There is not enough information for a conclusion.
4. Referring to the property table below for saturated liquid, using linear interpolation to determine the following values: a. Pat T = 94°C b. U at P = 0.4285 bar C. vat U= 315.67 kJ/kg Internal Energy, Specific Volume, v x 10 (m*/kg) U ("C) (bar) (kJ/kg) 0.3858 1.0259 313.90 75 80 0.4739 1.0291 334.86 85 0.5783 1.0325 355.84 90 0.7014 1.0360 376.85 95 0.8455 1.0397 397.88 100 1.014 1.0435 418.94
b) The variation in the experimental density of water, p, with temperature T, in the range of 20°C
Use the following TTT Diagram for the following questions: 800 A 1400 -Eutectoid temperature 700 1200 600 1000 500 800 400 600 300 Mistart) 200 50% 400 M+A M(50%) M(90%) 100 200 10-1 10 102 103 10 105 Time (s) Temperature ("C) Termperature (°F)
Thermodynamics Answer the following problem with complete solutions. Write legibly A balloon is filled with pure oxygen at 10 ℃. The balloon is released from the bottom of a water-filled testing pool and floats 30 m to the water surface (where the atmospheric pressure is standard). The volume of the balloon is 3,000 cm^3. The temperature is 25 ℃ at the surface of the water, and the water temperature at the bottom of the pool is 10 ℃. What is the volume of the balloon at the surface after it has come into thermal equilibrium with the surroundings