Rodney drove his bike with a velocity of 30 mph, went up to 90 mph, and went down to 20 mph. What is his average velocity?

Q: 5. A cubic meter of air at a pressure of 101.3 kPa and temperature of 15°C weighs 12.00 N. What is i...

A:

Q: (c) At the location 15 km downstream of the effluent discharge, how much oxygen (k8/d) would have to...

A:

Q: 3. An empty drum having a height of 4.5 m and a radius of 0.90 m is submerged in sea water (sp. gr. ...

A:

Q: 4. The hollow 6061-T6 aluminum shaft has an outer and inner radius of c, = 40 mm and c = 30 mm, resp...

A:

Q: The rate of the water flowing from a pipe is at 1500 gal/min. Convert this volume rate of flow in (a...

A: To convert the volume rate of flow to the given units.   Given, Volume rate of flow, say Q = 1500 ga...

Q: Figure below shows a cantilever member bent in the form of a quadrant of a circle with radius of 1.0...

A:

Q: Discuss in details why proper management of resources is a primary consideration in any engineering ...

A: Resource management generally refers to the action of planning, scheduling, allocation of people, te...

Q: Q3: Calculate the required column stiffness of single one- story structure to limit its acceleration...

A:

Q: Knowing that a force P of magnitude 750 N is applied to the pedal shown, determine (a) the diameter ...

A:

Q: Where is the centroid of the rectangular gate (typically represented by h)? 2 m below A 3 m below C ...

A:

Q: Urgent Hello please answer this problem as soon as possible. Topic is 'Fluid flow measurement' in Hy...

A: Given- 75-mm diameter orificed=0.075 mdischarge-Q=1734 litres/minHead over orifice h=5.5 m

Q: A pipeline (diameter U. from point P to point R (see figure). The piezometric heads at P and R are t...

A:

Q: An infinite slope is inclined at 22 degree. A plane of failure has developed at depth of 8 m from th...

A: Angle of slope, i =22°Depth of failure surface,z =8mdry unit weight of soil, γd =18 KNm3Saturated un...

Q: Situation 9: An 8m deep braced cuts in medium clay is shown. The unit weight = 16.5 kN/m3 and the un...

A: Excavation is the most common way of moving earth, rock or different materials with apparatuses, gea...

Q: Three bars pinned together at B and C and supported at hinges at A and D as show n in the figure bel...

A: Given:- The magnitude of the force at point B = 350 kN The magnitude of the force at point C = P Poi...

Q: 5. A piece of wood 305 mm square and 3 m long, weighing 6288.46 N/m³, is submerged vertically in a b...

A:

Q: If the proportion of soil passing 75 micron sieve is 30% and the liquid limit and plastic limit are ...

A: To find : Group index

Q: ineering projects that you think wo needed in Davao City. Discuss why think tbere's g peed for such ...

A: The following are the three environmental engineering projects that are needed in Davao city. 1.Wate...

Q: Solve for the reactions on the supports A,B,C&D of the two loaded Beams shown Below.

A:

Q: A one way slab having a simple span of 4.0 m has a thickness of 150mm. The slab is reinforced with 1...

A: Given data h = 150mm = 0.15m,  Span =4m Consider 1 m strip of slab,  b = 1000 m Dead load:  wd=?cbh...

Q: Two plates each with thickness t= 5 mm are bolted together with 6 - 22 mm diameter bolts forming a l...

A:

Q: One side of a regular octagon is "e". Find the area of the region inside the octagon. O 4.8e2. sq. u...

A:

Q: For an air-conditioning system, the outdoor and indoor design dry bulb temperatures are 45°C and 25°...

A: The given values are as followsThe  room dimension is 30×20×5Density(ρ)=1.2kg/m3The specific heat=1....

Q: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon...

A: Height of closed tank, H =18inchesDepth of carbon tetrechoride, H1 =4inDepth of water,H2 =2indepth o...

Q: Design a continuous one-way solid slab supported on beams spaced at 14 ft (4.2 m) on centers. The wi...

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the exac...

Q: Calculate the magnitude of the resultant force, FRin kN, to the nearest 10th. Pressure above fluid =...

A:

Q: A 8 m thick clay layer with single drainage settles by 120 mm in 2 years. The coefficient of consoli...

A: This question is related to the Consolidation from Geotechnical Engineering.

Q: A 8 m thick clay layer with single drainage settles by 120 mm in 2 years. The coefficient of consoli...

A:

Q: Determine the moment M that should be applied to the beam that in order to create a 25 mm compressiv...

A:

Q: 1. AASHTO Classification for Soil A 2. Group Index for Soil A 3. Group Index for Soil B

A: 1. Soil A classification Soil A Percent finer No. 200 = 30 < 35 Soil A will be among A-1 or A-2 o...

Q: Calculate the magnitude of the resultant force, Frin Ib, to the nearest 10th. Fluid: Oil with sg = 0...

A: Given: Specific Gravity of oil = 0.825 Total depth = 14+8 = 22 inch to find resultant force at 1/10t...

Q: The venturimeter shown has an pipe diameter of 500mm and narrows to a throat diameter of 200mm. If t...

A: As per guidelines we can solve one question at a time, please upload separately,Thanks To find disch...

Q: Draw the shear and moment diagram using the function of x and area method. 8 kN/m A B 3 m - 3 m-

A:

Q: The volume of tetrachloride having a mass of 1200 kg is 0.952 m^3. Compute the mass density and spec...

A:

Q: F = 250 lb 30% -X- 45° F, = 375 lb %3D

A:

Q: Generate the stiffness matrix for the frame corresponding to three degrees of freedom 1, 2, 3 nomeso...

A:

Q: a company uses a type of truck which costs P2M, with life of 3 years and final salvage value of P320...

A: Given data, Cost of truck P = P2000000 Salvage value S = P320000 Interest rate i = 4% Life = 3 years...

Q: Show all the key features, air-entry value, residual suction values and various zones of the SCWW (n...

A:

Q: PROBLEM 1: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 12 inch...

A:

Q: A simple beam with a span of 15 ft supports a uniform load of 800 plf, which includes its own weight...

A: Given data  Span length =15 ft UDL=800 p/ft What are the reactions of R2?

Q: What is the centroid pressure acting on the gate? O (1000)x(8) O (1000)x(6) O (9810)x(5) O (9810)x(6...

A: Given data in question  Water Density  Area of gate Depth of emersion To find out  Centroid pressure...

Q: In a construction project, the field moist unit weight was 18.08 kN/cu.m at a moisture content of 8%...

A:

Q: Is it always possible to use micrometer caliper and vernier caliper both device under the same circu...

A: Both vernier caliper and micrometer are used in industry for precise and accurate measurements inter...

Q: A pipeline (diameter 0.3 m, length 3 km) carries water from point P to point R (see figure). The pie...

A:

Q: A rigid bar AB is hinged at A and is supported by a rod CD at C. The rod is pin connected at D, as s...

A:

Q: A W 12 a x 72 is used as a column to carry an axial load P. The column has a fixed . oport at the bo...

A:

Q: For the given truss below, Determine the number of 16mm bolts to connect all the members @Joint B if...

A:

Q: Oil of sp.gr. of 0.750 flows through the nozzle shown and deflects the mercury in the U-tube gage. ...

A: The given data is shown below: Specific gravity=0.75Pressure at A=142 kPa

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as...

A:

Q: Question) Discuss the Plastic hinge length for thís case:- Cantliver beam with sedo load distributed...

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?