The figure below shows a ring distributor with interconnector BD. The supply is given at point A. The resistances of go and return conductors of various sections are indicated in the figure, current in the interconnector and voltage drop in the interconnector are: 10 A 0.075 2 |0.025 0.12 0.05 2/ 30 A 0.01 A 10 A 0.05 2 20 A E.

The figure below shows a ring distributor with interconnector BD. The supply is given at point A. The resistances of go and return conductors of various sections are indicated in the figure, current in the interconnector and voltage drop in the interconnector are: 10 A 0.075 2 |0.025 0.12 0.05 2/ 30 A 0.01 A 10 A 0.05 2 20 A E.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter33: Residential Utility-interactive Photovoltaic Systems

Section: Chapter Questions

Problem 6R: To size conductors and overcurrent devices for source circuits, you must multiply the module string...

See similar textbooks

Similar questions

If we increase the load than core loss and copper loss will... Decrease Increase Remain same
The principle operation of LVDT is based on the variation of Select one a. Self inductance b. Reluctance c. Mutual inductance d. Permanence
If the core of LVDT is at the middle, then the output voltage will be a. maximum b. minimum c. Output voltage is no relation with core position d. 0
use kirchhoffs Junction rule and loop rule to solve for currents I1 , I2 and I3..
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diodeshave? (Use constant voltage drop model for the Silicon diode) D IN4001 OV 10 kN IN4001 DELL
. Using the I – V curves how are ohmic materials different from non-ohmic materials
Identify the correct junction and loop rules, the solve for the missing currents using Kirchhoff’s Rules
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
ire D are made from the same material of resistivity p-2.0 - mm, and those of wire D are Lo-0.50.m and ro-0.75 mm. The wires are and 2? C
3. Show full solution. Magnetically coupled circuits.
To size conductors and overcurrent devices for source circuits, you must multiply the module string short-circuit current by ______________________.
Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.