Using the following reaction, H2SO4 (aq)  +   2 NaOH (aq)     Na2SO4 (aq) +  2 H2O (l) calculate the molarity of the H2SO4 solution if 14.92 mL of NaOH was necessary to reach the endpoint of a titration.  The molarity of the NaOH solution was 0.83 M and 25.18 mL of H2SO4 was added to the Erlenmeyer flask.

Q: Ammonium chloride (NH4Cl) is very soluble in water, 383 g/L at room temperature, and has a standard…

A: Addition of HBr would lead to the formation of ammonium bromide. The concentration of ammonium ions…

Q: If 0.045 g of KHP is used for titration, calculate the molarity (concentration) of the wood ash…

A: Given-> Weight of KHP = 0.045 gram Initial volume = 5.75 ml Final volume = 23.45 ml

Q: Suppose that extra volume (more than the actual volume) of 0.2 M NaOH solution was used to reach the…

A: fullscreen

Q: The hardness of water (hardness count) is usually expressed in parts per million (by mass) of…

A:

Q: The beaker contains 25. 00 mL of an unknown concentration of a CH3COOH aqueous solution and the…

A: An equation is called a balanced equation when the overall charge and mass of the reactants and…

Q: A chemistry student needs to standardize a fresh solution of sodium hydroxide. He carefully weighs…

A: It is acid-base titration. We knew that sodium hydroxide is not the primary standard solution. So we…

Q: 7.7 g of citric acid (MM = 192.1 g/mol) can be titrated with NaOH according to the following…

A: By stoichiometry of reaction : At equivalent point : Moles of H3C6H5O7 = Moles of NaOH  given mass…

Q: Potassium sorbate,KC H,O, (molar mass 150. g/mol) is commonly added to diet soft drinks as a…

A: Solution: Dissociation expression is a dissociation constant ( equilibrium constant). For acid…

Q: A chemistry student needs to standardize a fresh solution of sodium hydroxide. He carefully weighs…

A: A numerical problem based on quantitative analysis, which is to be accomplished.

Q: ou are given a sulfuric acid solution of unknown concentration.  You dispense 10.00 mL of the…

A: Titration is one of the most common method of qualitative analysis of substances given. It is done…

Q: Consider the diagrams given in the figure below to answer the following questions. Beaker A Beaker B…

A:

Q: The molarity of an unknown monoprotic acid 25.00 mL aliquot titrated with 9.37 mL of 1.15 M NaOH is…

A: The expression to find the unknown concentration from the known value is M1V1=M2V2 where  M1 and V1…

Q: Given the reaction below for the titration of sulfuric acid with sodium hydroxide, if 20.00 ml of…

A:

Q: In standardizing a solution of NaOH (40 g/mol) against 1.431 g of KHP (204.22 g/mol) the analyst…

A: Volumetric analysis is a method in which the volume of a substance is determined by measuring its…

Q: A 20.00-mL sample of aqueous oxalic acid, H2C2O4, was titrated with a 0.09113-M solution of…

A: Balanced chemical equation is as follows: Molarity of oxalic acid can be calculated by applying the…

Q: [Tutorial: Titration stoichiometry] This question will walk you through the steps of calculating the…

A:

Q: The titration of 25.00 mL of an unknown concentration of H2SO4 solution requires 44.58 mL of 0.42 M…

A:

Q: A solution of tartaric acid (H,C,H,O,) with a known concentration of 0.155 MH,C,H,O, is titrated…

A: Given values :- Concentration of tartaric acid (M1) = 0.155 M Concentration of NaOH (M2) = 0.425 M…

Q: (Eqn. 1)   1 OCl− + 3 I− + 2 H+ → 1 I3− + 1 Cl− + 1 H2O (Eqn. 2)   2 S2O32− + 1 I3− + 0 H+ → 3 I− +…

A: Given reactions are Reaction (1):    1 OCl− + 3 I− + 2 H+ → 1 I3− + 1 Cl− + 1 H2O Reaction (2):  2…

Q: 2. Suppose a titration needed 27.15 mL of 0.2497M HCI solution to completely react 25.00mL Ba(OH)2…

A: The number of moles of a substance is determined as the mass of a substance upon its molar mass. The…

Q: Malonic acid, H2C3H2O4 (aq), is a diprotic acid, so 2 moles of hydroxide ions are required per mole…

A: A neutralization reaction can be described as a chemical reaction in which acid and base react…

Q: 20.00-mL sample of aqueous oxalic acid, H2C2O4, was titrated with a 0.09113-M solution of potassium…

A: Solution- volume of the H2C2O4 =20.00 mLMolarity of KMnO4=0.09113 MThe volume of KMnO4= 23.24…

Q: The titration of 36.7 mL of sulfuric acid solution requires 43.2 mL of standard 0.236 M sodium…

A:

Q: A chemistry student needs to standardize a fresh solution of sodium hydroxide. She carefully weighs…

A:

Q: A student weighs out 1.051 g of impure KHP, dissolves the sample in deionized water and titrates it…

A: Given data Mass of impure KHP = 1.051 g Molarity of NaOH  solution = 0.1101 M Volume of NaOH…

Q: A solution of tartaric acid (H2C,H,O6) with a known concentration of 0.155 M H2C,H,O6 is titrated…

A: Given, H2C4H6O6+2NaOH→Na2C4H4O6+2H2OK. Concentration of tartaric acid = 0.155M Concentration of…

Q: The active ingredient in a certain toilet cleaner that claims to ‘remove lime scale and rust’ is…

A:

Q: A chemistry student weighs out 0.197 g of lactic acid (HC3H503) into a 250 mL. volumetric flask and…

A: When lactic acid is titrated with sodium hydroxide solution, then following balanced Chemical…

Q: A 25.00 mL sample of acetic acid (CH3COOH) is titrated to the equivalence using 31.08 mL of 0.1978 M…

A:

Q: A chemistry student needs to standardize a fresh solution of sodium hydroxide. She carefully weighs…

A: The reaction of oxalic acid and NaOH – H2C2O4 +2NaOH →Na2C2O4 + 2H2O

Q: An unknown vitamin C tablet was titrated with a 0.2030 M KOH solution. Calculate the milligram mass…

A: As vitamin C is the mono protic acid, 1 mole of vitamin C reacts with 1 mole of KOH. At equivalence…

Q: chemistry student needs to standardize a fresh solution of sodium hydroxide. He carefully weighs out…

A: Given-> Weight of oxalic acid = 54 mg = 0.054 gm  (1 gm = 1000 mg) Volume of oxalic acid solution…

Q: Titration of a 11.0 mLmL solution of HClHCl requires 32.4 mLmL of 0.11 MM NaOHNaOH. What is the…

A:

Q: The end point in a titration (stoichiometric / equivalence point) of a 50.0 mL sample of aqueous HCl…

A:

Q: A 27.56 mL portion of a 0.337 M solution of hydrochloric acid, a monoprotic acid, is to be titrated…

A: The chemical reaction between KOH and hydrochloric acid(HCl):                   KOH + HCl → KCl +…

Q: Part A: A volume of 90.0 mLmL of aqueous potassium hydroxide (KOHKOH) was titrated against a…

A: Hello. Since your question has multiple parts, we will solve the first question for you. If you want…

Q: You are given a solution of HCOOH (formic acid) with an approximate concentration of 0.20 M and you…

A: Chemical reaction:                             NaOH + HCOOH  →   HCOONa + H2O From well-balanced…

Q: A solution of citric acid (F3C6H507) with a known concentration of 0.200 M H3C6H507 is titrated with…

A:

Q: The SO2 present in air is mainly responsible for acid rain. Its concentration can bé determined by…

A: Molarity of the solution is equal to the number of moles of solute present in one liter of the…

Q: Molarity (M) of NaOH (from the bottle of NaOH): 0.204 mol/L Titration Number Final Volume buret…

A: An incomplete table based on volumetric analysis, which is to be accomplished.

Q: What is the concentration of NaCl in a solution if titration of 15.00 mL of the solution with 0.2503…

A: Silver nitrate reacts with sodium chloride to form precipitates of silver chloride and the solution…

Q: A student places 20.00 mL of 0.1005 M HCl in a flask and adds a few drops of phenolphthalein. She…

A:

Q: The reaction of sulfuric acid (H2SO4) with potassium hydroxide (KOH) is described by the…

A:

Q: Chlorine in wastewater could be digested, isolated and converted to HCl and could be titrated with…

A: Wate water contains many compounds which contaminate it. But these can be removed by many chemical…

Q: A volume of 60 0 mL of aqueous potassium hydroxide (KOH) was titrated against a standard solution of…

A:

Q: If you require 30.51 mL of .1090 M NaOH solution to titrate 10.0 mL of HC2H3O2 solution, what is the…

A: Chemical reaction between NaOH and acetic acid:                      NaOH + HC2H3O2  →  C2H3O2Na +…

Q: Potassium hydrogen phthalate is used as a primary standard in finding the concentration of a…

A: Potassium hydrogen phthalate is used as a primary standard in finding the concentration of a…

Q: For the titration of HOCl in bleach solution by Na2S2O4 the following reactions are used: HOCl-(aq)…

A: Reaction between HOCl in bleach solution and Na2S2O4 are represented as: HOCl-(aq) + H2O(l) + 2I-…

Q: The conversion of nitrogen to ammonia, an essential process in the nitrogen cycle, occurs only in…

A: Given, the reaction involved in the titration: The volume of the Mo3+ sample = 30 mL The volume of…

Q: A student measured 20 drops of vinegar and one drop of phenolphthalein solution into a well of her…

A: The titration of vinegar is carried out with NaOH. When the reaction is completed, then the number…