Water flows steadily along a horizontal open channel of uniform width, over a broad-crested weir. The channel bed upstream from the weir (to the left) is d metres above the channel bed downstream from the weir (to the right), as shown in the figure below. The volume flow rate per unit width is Q = 6 m2 s-1, and upstream the depth of the water is h1 = 3m. Take the magnitude of the acceleration due to gravity as a= 10ms-2

Water flows steadily along a horizontal open channel of uniform width, over a broad-crested weir. The channel bed upstream from the weir (to the left) is d metres above the channel bed downstream from the weir (to the right), as shown in the figure below. The volume flow rate per unit width is Q = 6 m2 s-1, and upstream the depth of the water is h1 = 3m. Take the magnitude of the acceleration due to gravity as a= 10ms-2

Name: Water flows steadily along a horizontal open channel of uniform width
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Water flows steadily along a horizontal open channel of uniform width, overa broad-crested weir. The channel bed upstream from the weir (to the left) isd metres above the channel bed downstream from the weir (to the right), asshown in the figure bel

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water áows in a rectangular channel of width, w. In some cases, the water may suddenly increase in elevation as shown in the figure (from h1 to h2) through a highly disturbed region called a hydraulic jump. Assume the velocity is uniform at stations 1 and 2, and assume the pressures are distributed hydrostatically. Using the Bernoulli equation and whatever other necessary equation(s), finnd the equation (cubic) for the downstream depth, h2, in terms of h1, V1, and g.
You’ve sent your assistant out to measure the flow properties of a frictionlessrectangular flat channel. Your assistant returns with measurements for the depth (d2 =1.4 m), the specific discharge (q2 = 10.0 m2/s), and (somehow) the height of the energygrade line at 4.0 meters all at the downstream cross section. They haven’t done aspectacular job leaving you to solve for d1, q1, V1, and V2. There are two potentialanswers for d1 and V1.
6. Draw the hydrograph and flow duration curve for the following data. Also find avera powerdevelo ped ifthe head is 100 m and efficiency is 90%. Discharge Week Week Diss harge 100 800 2 200 600 300 1000 1200 10 600 600 900 11 400 6. 12 200
Two branches of water pipe merge to form a larger diameter as shown figure below. At a location at the junction (before completely merging) the nonuniform profile is observed at the depth of 6 ftDetermine the value of V (ft / s) .
In flood stage a natural channel often consists of a deepmain channel plus two floodplains, as in Fig. Thefloodplains are often shallow and rough. If the channel hasthe same slope everywhere, how would you analyze thissituation for the discharge? Suppose that y1 = 20 ft, y2 =5 ft, b1 = 40 ft, b2 = 100 ft, n1 = 0.020, and n2 = 0.040,with a slope of 0.0002. Estimate the discharge in ft3/s.
Water in a horizontal channel accelerates smoothly overa bump and then undergoes a hydraulic jump, as inFig. If y1 = 1 m and y3 = 40 cm, estimate (a) V1,(b) V3, (c) y4, and (d ) the bump height h.
A water diffuser is constructed like that in the figure below. Diffuser wall 2 m Flow Entrance 7 m Exit The volumetric flow rate at the entrance (per meter depth into the plane of the image) is 14.0 m2/s and the pressure difference Pexit - Pentrance = 350 kPa. What is the expansion angle in degrees? i
A hydraulic jump is shown in figure below. The depth of flow z₂ after the hydraulic jump is 5 m larger than z₁. The total flow rate in the channel is 450 m³/s and the channel width is 50 m. The length / over which the jump occurs is 0.4 m. ax= If the depth, z₁, is 6 m then what is the average acceleration (ing's) of the liquid as is flows across the jump. 0.21 Hydraulic jump g's V₂
3. The daily streamflow data of a river for a drainage area of 5,810 km are given in table below. Determine the equivalent depth of the direct runoff by separating the baseflow. (Use recession curve method- N-0.8A) Time (days) Flow (m'/s) 1,600 1,550 5,000 11,300 8,600 6,500 5,000 3,800 Time (days) Flow (m/s) 2,800 2,200 1,850 1,600 1.330 1,300 1,280 9. 10 11 12 13 14 15 1234 n078
An irrigation channel is to carry a discharge of 14 cumec with a velocity of 0.9 m/s and bed slope of 1 in 2500. The side slopes are 1 to 1. Find the depth and bottom width. The values of Chezy" C for this channel for different values of hydraulic radius R are as tabulated below. Hydraulic radius R 0.7 0.8 0.9 1.0 1.1 1.2 1.3 1.4 Chezy's C 34 35 37 38 39 40 41 41
1. Three reservoirs are connected by individual pipes to junction O as shown on the figure below. Find the elevation of reservoir C in order that the discharge in pipe AO from reservoir A is 0.15 cubic meter per second. Use Darcy-Weisbach formula with f= 0.02. Draw the final hydraulic gradient line (HGL). Discharge, Q |(m³/s) 0.15 (out) Length, L (km) 1.40 Reservoir Diam., D (cm) WS elev. (m) A 35 145 ? 25 0.90 125 ? 30 1.60 A B
Show In details whether the following equation for flow over a rectangular weir, call modified Francis Formula, is dimensionally consistent: Q =0.415(L - 0.2h.)(h)(2gjas Where: Q= volumetric flow rate, ft'/s; L= crest height(ft); ho- weir head (ft) and g- acceleration due to gravity (32.2 f/s) O Focus States) Accessibility: Investigate