Answered: What is drag? What cause it and why do…

Engineering

Mechanical Engineering

What is drag? What cause it and why do we usually try to minimize it? Explain

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.50P

See similar textbooks

Related questions

Q: 4) Some fish that evolved to live at extreme depths essentially explode if they are Petad by an…

A: Given, The cross-sectional area of the fish Assumptions: Water is incompressible The value of…

Q: Most of you have seen car advertisements where the car manufacturerbrags about how fast one of its…

A: Inital velocity,u=0 km/h =0 m/sFinal velocity,v=100 km/h =27.78 m/sTime taken,t=6.7 secCar engine…

Q: From an analysis of wind speed data (hourly interval average, taken over a one-year period), the…

Q: Question (1): The ship in Figure (1) is subjected to a drag Fp on its hull, created by water passing…

Q: On an alien planet (with unknown gravity), a 5 kilogram object is dropped froim rest 10 meters above…

Q: E Review I Constants The Dyson sphere is an hypothetical spherical structure centered around a star.…

A: Write the mass of the sun. msun=2×1030 kg Write the density of the spherical shell. ρ=3900…

Q: B46 Two copper wires A and B, of the same known arcas of cross-section, are subjected to mea- sured…

A: Solution:

Q: 1) At any time, approximately 20 volcanoes are actively erupting on the Earth, and 50–70 volcanoes…

A: Given that, μ=μ±∆μ×100=4×103±1%ρ=ρ±∆ρ×1002.5±1%t=t±∆t=28±0.5α=α±∆α=10°±1°g=g±∆g=9.81±0 Flow rate can…

Q: An alpine ski jumper can fly distances in excess of 100 m by using his or her body and skis as a…

Q: The nuchal ligament in a horse supports the weight of the horse’s head. This ligament is much more…

A: From the stress-strain curve,

Q: A ball is dropped from a building. How fast is it traveling after falling for 1.77 s? (Hint: It's a…

A: Given, Time at which velocity is to be found = t = 1.77 s Type of motion : Free fall In case of…

Q: A sphere (Cd = 0.2) 1 ft in diameter travels at 100 ft/sec in standard atmospheric air. What is the…

Q: What trigonometric identity may be used to summarize an equation for calculating tension force (the…

A: As per our guidelines we are suppose to answer first question only. The tension force can be…

Q: Heat transfer Question Please explain how to write an excel spreadsheet that will calculate the…

Q: What is the major difference between spacecraft orbital mechanics and spacecraft attitude dynamics?…

A: given; major difference between spacecraft orbital mechanics and spacecraft attitude dynamics?

Q: a) the aspect ratio of the wing, the wing lift coefficient , and the induced angle of attack.

Q: tmin [In(a + bh2)- In b %3D

A: 777-300 is the name BOEING is the manufacturer. body :- Wide Fixed-wing aircraft Low wing position…

Q: 1. Differentiate between kinematic similarity and dynamic similarity.

A: The theory of similarity calls for three major hydraulic model test conditions to be satisfied,…

Q: What are the two common numerical/analytical methods that we use for in Engineering Mechanics:…

A: Truss: It is a structure that consists of a two force members only where this members are organized…

Q: A tentative rule was given about tipping in Testing Experiment Table 8.4, where if a vertical line…

A: Given Width, w = 13 cm Height, h = 20 cm Find The angle

Q: These dimensions concern transportation systems. Look up the dimensions of the following vehicles;…

A: DISCLAIMER….. SINCE YOU HAVE POSTED A QUESTION WITH MULTIPLE SUBPARTS WE WILL SOLVE FIRST THREE…

Q: The Reynold's number of a sphere falling in air is 1E6. If the sphere's radius is 1ft, what is its…

A: Given data: The Reynold’s number of a sphere falling in air, Re=1E6=1×106 The sphere’s radius, r=1…

Q: The speed of your automobile has a huge effect on fuel consumption. Traveling at 65 miles per hour…

A: Speed is defined as the ratio of distance to the time period, which means that speed is the distance…

Q: ere we are looking at a large billboard that will be exposed to a wind load. Use the table to find:…

A: x/y = 4/2.5 = 1.6 cd= 1.1

Q: Let's say that the semiempirical binding energy formula is Eb= aA-bA^2/3 - s(N-Z)^2/A -dZ^2/A^1/3…

Q: The drag force of a new sports car is to be predicted at a speed of 65 mi/h at an air temperature of…

Q: In order to fest the flow the surface of an airplane wing, a model is built to a scale of 1/17 and…

A: First, calculate the dynamic viscosity of water at 20 degree-Celcius as follows.

Q: Viscosity. From studies of the flow of neutrophils in micropipets, it is possible to measure the…

A: a) For Newtonian fluid the viscosity of the fluid is independent of the rate of deformation that is…

Q: Find the distance of load from the nozzle in meter

A: Given: A water jet F=150.9 N v0=17.9 m/s d=3.9 cm To determine: The distance of load from the…

Q: The air resistance to the motion of a vehicle is something important that engineers investigate. As…

A: Write the given equation:

Q: What should be the surface tension of a liquid if its density, which is 1.44 g/cc, is the same as…

Q: How do you determine which type of trendline to use on a graph? The accepted or proposed…

A: The best fit parameter value (R2) is the type of trendline to use in graph

Q: Question 5 a) A 1:20 scale model of a surface vessel is used to test the influence of a proposed…

A: a) Equating Froude number for model and prototype - Frm=FrpVlgm=VlgpConsidering change in g value as…

Q: Question 21 The drag on a moving object, at a fixed speed, is measured to be 24 N. Assuming that the…

Q: 1. Energy consumption in a country from 2001 to 2011 increased from 1041.3 million to 1526.1 million…

A: The measurement for doing work is known as energy. Electrical energy is defines as a movement of…

Q: Viscosity is defined as the measurement of the resistance of a fluid to gradual deformation by shear…

A: The sphere is initially driven downward, so that the upward force is smaller than the downward…

Q: A vintage sports car (850 kg) moves at a constant speed of 72 km / h on a road with a gradient of…

Q: Horizontal stream with water with a cross sectional area of 0.1 ft2 and a velocity 40 ft/s has…

A: given data cross section area = 0.1 ft^2 velocity = 40 ft/sec find the kinetic energy.

Q: If a ball rolls up a ramp to a height of .3 m on the ramp (inclined at an angle of 20 degrees), what…

Q: Gust loads on an aircraft wing are mainly a structural problem for:

A: Answer= (c)

Q: on the velocity (V), the density several lineor dimension, h, Lapressure drep qus A fluid flow…

Q: 8. This question is based around an aircraft with the following characteristics: Co = 0.04 + 0.025…

Q: explains how the two methods of parameter estimation, namely the method of parameter estimation and…

A: given; explains how the two methods of parameter estimation, namely the method of parameter…

Q: data Tube Area=7.854× 10-5 Air Temperature= 34 c water temperature=28 c the tube's diameter=10cm

A: Reynolds number : It is the ratio of inertial forces to viscous forces within a fluid which is…

Concept explainers

Project Management Techniques

The guideways or the roadways that are undertaken to perform a project efficiently and all the tools required to accomplish the task are the general outlines for project management techniques.

Question

I need handwritten only with 0 plagiarism I repeat handwritten And 0 plagiarism I'll check the plagiarism mysllef if I found so better check yourself after completing the ans for plagiarism

What is drag? What cause it and why do we
usually try to minimize it? Explain
your answer.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Thrust is required to propel an airplane at a fi nite forwardvelocity. Does this imply an energy loss to the system?Explain the concepts of thrust and drag in terms of the fi rstlaw of thermodynamics.
Based strictly on your understanding of the flat-plate theoryplus adverse and favorable pressure gradients, explainthe direction (left or right) for which airflow past theslender airfoil shape in Fig will have lower total(friction 1 pressure) drag.
A cloud of coal particles is traveling through a system. The cloud diameter estimated to be 0.027 m and the individual particles are 50 um in diameter with the density of 1300 kg/m'. The total cloud is moving such that its drag coefficient is constant at 0.44. The individual particles in the cloud move much slower, such that the drag coefficient given by stock's law. The system has atmospheric air transporting and the cloud density is 190 kg/m3. Determine the ratio of internal velocity to cloud velocity. Atmospheric air density 1.2 kg/m'.
What is the effective angle of attack ? What is the induced drag ? Show them by drawing a sketch and explain.
is the drag coefficient 2 or 0.2?
During a high Reynolds number experiment, the total drag force acting on a spherical body of diameter D = 11 cm subjected to airflow at 1 atm and 5°C is measured to be 5.0 N. The pressure drag acting on the body is calculated by integrating the pressure distribution (measured by the use of pressure sensors throughout the surface) to be 4.75 N. Determine the friction drag coefficient of the sphere.
Use FoilSim to investigate how an aircraft wing produces lift and drag by changing the values of different factors that affect lift and drag
A parachute of hemi-spherical shape allows a parachute jumper of weight 90kg to descend with a steady velocity of 8 m/s ignoring air movement. The drag coefficient of parachute as determined from experiments is 1.5. Take the density of air as 1.2 kg/m³. The drag force will be equal to O 90 N O 720 N 883 N O 1156 N
In the vertical wind tunnel used in paratrooper training, find the wind tunnel free speed required to keep a 75 kg person suspended in the air in a horizontal position. The height of this person is 1.7m and the width is 38cm and the front drag coefficient is around 1. Atmospheric pressure and temperature inside the tunnel are Patm = 85kPa and T = 25C, respectively.
What is the effect of streamlining on (a) friction drag and (b) pressure drag? Does the total drag acting on a body necessarily decrease as a result of streamlining? Explain.
During a high Reynolds number experiment, the total drag force acting on a spherical body of diameter \{D=\) 7 cm subjected to airflow at 1 atm and 5°C is measured to be 5 N. The pressure drag acting on the body is calculated by integrating the pressure distribution (measured by the use of pressure sensors throughout the surface) to be 2.1 N. Determine the friction drag coefficient of the sphere. For the same values as above, find the velocity of air during the test. Given that density and viscosity of air at 50C5oC are 1.269kg/m3 and 1.754×10-5kg/ms.
From Table the drag coefficient of a wide plate normalto a stream is approximately 2.0. Let the stream conditionsbe U∞ and p∞. If the average pressure on the front of theplate is approximately equal to the free-stream stagnationpressure, what is the average pressure on the rear?