Why do we apply reduction factors in the design of electric equipment? Also, why do we increase the amperage for continuous loads? Give illustrations to further explain your point.

Q: An inductor (10 H) and resistor (1 ohm) are linked in series with an electromotive force (emf) E = E...

A: We need to find out maximum current and time at which we get maximum current.

Q: The Si transistor has = 50 and negligible leakage current. Let VCC =18 V, VEE = 4V; RE =200 , and R...

A:

Q: Find the transfer function, G(s) = VL / V(s). 10 1F WHE 1Q 10 i|(t) IF 2H

A: The solution is given below 

Q: A uniform electric field intensity of E, =-2a, +4a, - 6a, kV/m exists at z0. Determine: (a) The norm...

A:

Q: Q3: What is the value of Io in the circuit using loop analysis? Write your answer in time domain.

A: The given circuit is shown as:

Q: Question 4: The Transformer A current transformer is used to provide a range of values of 5A, 1A and...

A: Current transformer and voltage transformer is an measuring instruments which measure the currents a...

Q: Find the Norton equivalent at terminals a-b of the circuit in the figure. Take Vs= 18 V. 0.25 vo 2Ω ...

A:

Q: Draw the diagram of a halfwave power supply circuit and a fullwave  supply circuit. Aside from  the ...

A: Full-wave supply circuit: This circuit has four diodes and has two pulses in one time period. Its ou...

Q: differentiator has an input of sin wt calculate the output voltage given the following values; R = 1...

A: In this question we will find output voltage for differentiator.....

Q: G8(s) R(s) G6(s) G1(s)- G3(s) C(s) G7(s) G2(s)가 G4(s) G5(s)

A:

Q: A three-phase, six-pole, 60 Hz, 230-volt wound rotor motor has its stator connected in delta and its...

A: Given Estator =230 volts.                                 Fstator=60Hz Nrotor=0.8 *Nstator.         ...

Q: 10 R 2V -10+ 3V

A: We need to find out output voltage for given circuit

Q: Calculate the conductance, susceptance and admittance of an impedance that is equal to Z = (3.6 + j4...

A:

Q: What is a single-phase induction motor? How does a single- phase induction motor work? How do you te...

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: Derive [h] parameters in terms of [T]. a: b: Derive [z] parameters in terms of [y].

A:

Q: Find the EFS coefficients of the following x(t). The using this result, find EFS coefficients of oth...

A:

Q: 30. A single phase transformer has percentage regulations of 4 and 4.4 for lagging power factors of ...

A:

Q: 1. An impedance equal to 4.4/60° ohms is connected across a 220volt source. What should be the value...

A: Voltage ampere of  load = voltage ×current * Total source power = sum of the each load powers . Tota...

Q: The operating point values of current I C (=I CQ ) and voltage VCE (=V CEQ ) in the circuit have mag...

A:

Q: Albert Dela Cruz e forward path transfer function is given by G(s) = 2/s(s+3). Obtain an 5 points %3...

A:

Q: zero. a. Find the charge on the capacitor at t=6ms b. Find the voltage on the capacitor att= 10ms A)...

A:

Q: Determine the inverse laplace transform of the following: a. 1/[(s-2)^2 + 9] b. s(s^2 - 9)/(s^2 +9...

A:

Q: A 4- pole50 Hz turbo generator supplying 50% of its maximum power capability to 0.6 pu load. The ope...

A:

Q: a) Find the equivalent resistance and current (I) pass through the circuit shown in Fig. (4.a), Cons...

A: Equivalent Resistance Req = 25 ohms.  Current I = 1 Ampere.  Explanation provided below. Please go t...

Q: Use capital letters.What would be the equation of an NAND gate if the inputs are A,B and the output ...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for y...

Q: + Vin VoL R T. 5V

A:

Q: 2.The voltage across a 10 Q inductive reactance is: v(t) = 100 sin wt. a. What is the sinusoidal exp...

A:

Q: The slope of the tangent line at any point (x, ) on a curve is 2,/x. If the point (9, 3) is on the c...

A: The solution is given below 

Q: Draw the block diagram of the transmitter and receiver and give the functions of the components invo...

A: Block diagram for transmitter and receiver system,

Q: (b) A 15-kVA, 2300/230-V transformer is to be tested to determine its excitation branch components, ...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts f...

Q: Find the load current and power delivered to the load, using thevenin's theorem ? 22 32 24V 82 RL 두

A: We need to find load current and load power for given circuit

Q: $4.7k2 a Kd -IDV

A: We need to find out the voltage for given circuit .

Q: When provided with a three-stage system that has an input power of Pin = -26 dBm and power gain of t...

A:

Q: A moving coil mili voltmeter has a resistance of 20 ohm and full scale deflection of 120 degrees is ...

A: Givenresistance of voltmeter=20 Ωdeflection=120°potential difference=100 veffective dimensions=3.1cm...

Q: (A) Determine the steady state error for the following system shown in Fig.1 for unit- ramp input. R...

A:

Q: What is the phase current?

A:

Q: B. Solve for z: (b) In z= e – ni

A:

Q: oY(s) U(s). 4.

A:

Q: values for the same component. This causes different signed power therefore we cannot state whether ...

A: Simple solution regarding this chaos: If the current is discharging from any device that means if th...

Q: Given that the lightbulb is rated 230 v, 0.5 A. Find the current across the 40 Q resistor and 80 Q r...

A:

Q: D4.2. Calculate the work done in moving a 4-C charge from B(1,0, 0) to A(0, 2, 0) along the path y =...

A:

Q: a) Using Nortel voltage rot the al, culculat V 多42

A: Please refer the attached images for the complete answer..

Q: An inductor (1 H) and resistor (0.1 ) are joined in series with an electromotive force (emf) E = E(...

A:

Q: 3. A radio, its receiver has a sensitivity of 2x10^-4 V/m.  What is the maximum radio distance (as a...

A:

Q: (A B) u²– 1 du 2 | cosu du D -2 | sinu du

A:

Q: gadpd puog uous pau p ui yonnios unok aɔDIA 1. Two shunt generator in parallel have each armature re...

A:

Q: 1. Given the sequence, x(n) = u(n) find the z transform of x(n).

A:

Q: et sin3t sin 3t

A: As per our guidelines we are supposed to be answer only the first question. Kindly repost the other ...

Q: Problem 1 For the periodic function in figure shown, specify: a. wo in radians per second b. fo in h...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for y...

Q: An amplifier has a loop gain of -200 and a feedback of 0.10 is added. If the loop gain change to 250...

A:

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.